BY1826 3color printing slotting die cutting machine

Function and Characteristics

* Feeding Unit

• This machine adopts chain feeding system, equipped with side gauge make sure feeding paper accurately.
• Abrasion resistance materials as the support of the bottom of chains, fast running, low noise .
• Main motor placed under the feed table.
• Equipped with block paper steel bar to ensure the easy feeding of the bend cardboard.
• Feeding error ±1.5mm.

* Printing unit

• Printing roller, paper feeding roller, pressure roller, all the surfaces grinding, hard chromium plating.
• Adopt planet style electrical adjustment of 360 degrees whatever operating and stopping, quickly and accurately.
• Motorized shift and pneumatic locking up of printing units.
• Inking roller can be detached from printing plate automatically to avoid damage the printing plate.
• Inking roller equipped idling running device to prevent ink from being dried when machine stop.
• Pneumatic lifting and down the anilox roller, auto ink distributing.
• With Pneumatic diaphragm pump to supply ink.
• Main transmission gears are made by 45#steel after high frequency quenching.
• Drive part adopts spray lubricating system, improve the precision and serve life of machine.

n Main shafts connect with gear used no-key connect(ringfeder), so keep shaft running stably.

• Transmission part adopts automatic spray lubraction system, improve machine use time and precision.
• All gears adopt cross slide head to perform no gap adjustment, printing accurately.
• Manual adjustment of the printing roll axial position 15mm.
• Printing precision±0.50 ㎜(when the paper board is plane and smooth).
• Auto count device properly controls production volume..

Option device: hang plate grove

• Slotting unit

• The slotting knives pedestal can be worm-type adjustment according to the thickness of card board. ( Three & Five layer only).
• The slitting knives pedestal can be worm-type adjustment according to the thickness of card board. ( Three & Five layer only).
• The back slotting knife (Height of the box) Four knives adjustment synchronous, easy working.
• Electric adjustment Printing phase and slotting position.
• 7mm alloy steel slotting knives with indent heat treatment to enable grinding teeth sharp edge.

Option: Slotting and crease joint movement by hand or motorized control Hand hole device

• Die cutting unit

• Automatic compensation device for linear speed of rubber cushion roller to prolong the service life of superior adhesive.

• Automatic lateral movement of cushion roller 40 mm from left to right, prolonging the service life of superior rubber
• When the rubber pad is used unevenness, can open the function of the rubber roller, prolong the service life of the rubber pad.
• Adopt high-quality Germany Depair rubber pad.
• The roller is made of cast steel, with a wall thickness of 45mm,
• Pneumatic manual or automatic control of die cutting roll, die cutting roll to lift cutting paper, stop the paper feed to fall to avoid damage to the rubber pad.
• Electrically adjusted phase die-cutting position
• The transmission gear is automatically sprayed and lubricated, and the service life of the gear is prolonged.

Main Technology Parameters