0-10V output PVDF water level meter for iot water level monitoring
1.Features
2.Dimension
Unit in the diagram is mm.
3.Description
The 0 - 10V output PVDF water level meter is an essential tool for IoT water level monitoring. Constructed with PVDF material, it exhibits excellent corrosion resistance, ensuring reliable performance in diverse water quality and environmental conditions. The 0 - 10V output provides a proportional voltage signal that corresponds precisely to the water level. This makes it highly compatible with a wide array of IoT-enabled devices and systems, facilitating seamless integration and data transmission. It enables real-time and accurate water level measurements, which are crucial for applications such as flood prevention, water supply management, and industrial process control. With its advanced features and compatibility, it empowers efficient and intelligent water level monitoring in the era of the Internet of Things.
4.Low power consumption mode
Work mode set to 2 is low power concumption working mode.
How to realize the low power consumption ultrasonic level and distance sensor
a) Use low power ICs
We use almost new ICs by wich the power consumption is normally low.
b) Controll the power of each circuit in the sensor.
There are three parts of the circuit in the sensor, the transmitting circuit, the receiving circuit and the basic circuit of the mcu. The mcu realizes power consumption management by enabling control of the work of each part of the circuit, and then controls the power consumption.
c) When the mcu itself is not working, it enters sleep mode to further reduce power consumption.
5.Installation conditions
If the sensor is installed at the environment temperature fall below 0℃, It should do well on the protective measures. In case of direct mounting of the sensor in a through hole using the steel nuts, it has to be fixed at the middle of the housing thread.
6.Ordering information
KUS | Model | Output | Max range | Description |
550 | ||||
Customized | ||||
SW-1 | Switch Output,SW-1 for one switch output,SW-2 for 2 switch outputs | |||
mA | 3 wire 4-20mA output | |||
5V | Output is Vout 0-5V | |||
3V | Output is Vout 0-3V | |||
RS485 | Output is RS485 | |||
TTL | UART TTL output | |||
XX m | XX m is the maxim range can be detected, the max range is 5 meters Default is 2.5m | |||
KUS | 550 | RS485 | 2m |