OPA4314AIPWR Operational Amplifier Chip OPA4314 SSOP-14 OPAMP
Product Attribute | Attribute Value |
---|---|
Texas Instruments | |
Operational Amplifiers - Op Amps | |
SMD/SMT | |
TSSOP-14 | |
4 Channel | |
5.5 V | |
3 MHz | |
20 mA | |
1.5 V/us | |
2.5 mV | |
1.8 V | |
- 40 C | |
+ 125 C | |
10 pA | |
150 uA | |
No Shutdown | |
66 dB to 80 dB | |
OPA4314 | |
Cut Tape | |
MouseReel | |
Reel | |
Amplifier Type: | Low Power Amplifier |
Features: | EMI Hardened |
Input Type: | Rail-to-Rail |
Output Type: | Rail-to-Rail |
Product: | Operational Amplifiers |
Supply Type: | Single |
Brand: | Texas Instruments |
Moisture Sensitive: | Yes |
Operating Supply Voltage: | 1.8 V to 5.5 V |
Product Type: | Op Amps - Operational Amplifiers |
Factory Pack Quantity: | 2000 |
Subcategory: | Amplifier ICs |
Unit Weight: | 0.002018 oz |
The OPA314 family of single-, dual-, and quad-channel operational amplifiers represents a new generation of low-power, general-purpose CMOS amplifiers. Rail-to-rail input and output swings, low quiescent current (150 µA typically at 5 VS) combined with a wide bandwidth of 3 MHz, and very low noise (14 nV/√Hz at 1 kHz) make this family very attractive for a variety of battery-powered applications that require a good balance between cost and performance. The low input bias current supports applications with MΩ source impedances.
The robust design of the OPA314 devices provides ease-of-use to the circuit designer: unity-gain stability with capacitive loads of up to 300 pF, an integrated RF/EMI rejection filter, no phase reversal in overdrive conditions, and high electrostatic discharge (ESD) protection (4-kV HBM).
These devices are optimized for low-voltage operation as low as 1.8 V (±0.9 V) and up to 5.5 V (±2.75 V), and are specified over the full extended temperature range of –40°C to 125°C.