Custom Rogers,Taconic,Isola,F4B PCBs are our forte. We enjoy working with clients who can give us a challenge. Our Rogers and other high frequency PCBs can be created in many shapes and size. We have the capabilities to create RF printed circuit boards with large panel sizes up to 18" x 24".

We work alongside our clients to design every aspect of the PCB,not only rogers,Taconic,F4B PCB board,we also supply FR408HR, 370HR, and FR406 board.

The fabrication process is completed using a variety of high-end technologies. Our fabrication methods include scoring and array layouts among others. We utilize laser technology to accurately complete our trimming, drilling, and routing processes.

We offer eclectic options for circuit board tracing, etching, and soldering. We also offer silk screen printing in white, red, black, and yellow.

The whole plate gold plating we mean refers to "electroplating gold", "electroplating nickel gold plate", "electroplating gold", "electric gold" "electric nickel gold plate", a distinction between soft gold and hard gold (generally hard gold is used for gold fingers). The principle is to dissolve nickel and gold (commonly known as gold salt) in chemical water and dip the PCB into the electroplating cylinder. The nickel gold coating is generated on the copper foil surface of the circuit board. The electric nickel gold is widely used in electronic products because of its high hardness, wear resistance and difficult oxidation.

What are the benefits of PCB Gold plating?
Anti-oxidation, protection of the bottom layer Ni and copper
Gold wear resistance, good reliability
Gold finger, mainly using the good conductivity of gold

RF is Radio Frequency, which refers to radio frequency, high frequency signal,RF PCB can be defined as a PCB with an analog signal in the frequency range of 30MHz to 6GHz. However, whether a lumped or distributed parameter model is used can be determined according to the formula.

RF printed circuit board PCB thickness is usually an integral multiple of 0.2mm, such as 0.8mm, 1.0mm, 1.6mm, etc. Sometimes printed circuit board sheet thickness is also expressed in inches. The specific thickness should be based on the results calculated by the impedance control.The precision of the characteristic impedance must be strictly controlled in the manufacture of RF circuit boards.