Clean Energy Chinese Biogas Generator 130KW 3 Phase CE Approved
CONNECTIONS TO A BUILDING’S ELECTRICAL SYSTEM
Connections for generator to a building’s electrical system must be made by a qualified electrician. The connection must isolate the generator power from utility power, and must comply with all applicable laws and electrical codes.
Gurantee
Within the guarantee period
Replace any part(s) for free which is found to be defective under normal use and service, in accordance with the maintenance schedule, and SevenPower pays for the transportation cost.
CHP Main Specifications
Model | SP130B | |
fuel | — | Biogas |
marks | — | Synchro CHP |
electrical output(KWe) | kVA/kWe | Continuous Power |
162/130 | ||
frequency | Hz | 50 |
voltage | V | 400/230 |
gas inlet pressure | kPa | 3-5 |
dimension (soundproof type) | mm*mm*mm | 2900*1600*1800 |
net weight | kg | 3500 |
Biogas consumption | m3/kW.h | 0.42 |
Biogas consumption for one hours | m3/h | 54.6 |
db(A)@7m | — | 59 |
Certificate | — | CE |
ignition system | — | Impco |
speed governor | — | Woodward |
gas filter | — | Madas |
zero regulator | — | Kromschroeder |
MCB | — | ABB |
GCB | — | ABB |
Controller | ComAp | |
Engine model | — | STYER T10 |
Engine type | — | 6 cylinders,4stroke,water-coolled |
RPM | — | 1500 |
Compression Ratio | — | 11.0 |
Displacement | — | 9.726L |
Oil capacity | — | 24L |
Charging voltage | — | 24V(DC) |
Charging current | — | 5A(DC) |
Starting system | — | Electic-start |
model | — | Meccalte |
phase | — | 3 phase 4 wires |
insulation system | — | class H |
protection | — | IP23 |
Cooling Type | — | air cooled |
Characters
Environmentally friendly design.
Long time R & D and testing ensure high reliability.
Comprehensive heat insulation to minimize heat loss.
CHP inner pipelines are made of full stainless steel material.
Maximum lower the noise level.
Maintenance friendly thanks to easy access.
Biogas Requirements
Composition | Content |
CH4 | ≥55% |
fluctuations value of biogas in pipeline | <0.2Kpa |
hydrogen | <10% |
sulfide, including hydrogen sulphide | <200mg/m3 |
chlorine fluorine compounds,mainly chlorofluoromethane | <15mg/m3 |
silicium | <0.7mg/m3 |
ammonia | <15mg/m3 |
liquid oil and hydrocarbons | <50mg/m3 |
particles | <5μm Impurity content<30mg/m3 |
For more information about each CHP, please consult with your sales representative.Thanks.