10Gbps XFP WDM ER60 Ethernet Fiber Transceiver Module 1330nm/1270nm 60km DOM
Description
Gigaopto’s XFP WDM ER60 is Multi-Vendor MSA Compatible XFP (10 Gigabit Small Form Factor Pluggable Module) Transceiver. The transmitter section uses a 1330nm DFB, the receiver section uses a 1270nm PIN photodiode receiver, which provides 60km transmission over single strand single mode fiber (G.652 SMF).
It supports DDM/DOM optical diagnostics, which provides diagnostic information about the present operating conditions.
Specification
Compatible Brand | Cisco | Part Number | GTX-B3296-60DC |
Packaging | XFP WDM | Bit Rate(Gbps) | 10.3 Gbps |
Wavelength (TX/RX) | 1330nm/1270nm | Link Distance | 60 |
Connector | LC Simplex | Media | single-mode fiber |
Tx Part | DFB | Rx Part | APD |
TX Average Power | 1 ~ 5dBm | RX Sensitivity | < -20dBm |
Ext. Ratio | > 3.5 dB | Saturation Input Power | > 0.5dBm |
Power Budget (dB) | 21 dB | Operating Temperature | 0 to 70°C / -40 to 85°C |
Power Dissipation | < 2W | OEM/ODM | Support |
DDM/DOM | Support (default) | Warranty | 36 months |
Protocols | 10G Ethernet, 10G FC, 8G Fibre Channel, OTU2, STM-64 |
Features
Applications
Optical and Electrical Characteristics
Parameter | Symbol | Min | Typical | Max | Unit | Notes | |
Transmitter | |||||||
Centre Wavelength | λc | 1320 | 1330 | 1340 | nm | ||
Spectral Width(-20dB) | Δλ | 1 | nm | ||||
Side-Mode Suppression Ratio | SMSR | 30 | dB | ||||
Average Output Power | Pout | +1 | +6 | dBm | 1 | ||
Extinction Ratio | ER | 3.5 | dB | ||||
Data Input Swing Differential | VIN | 180 | 950 | mV | 2 | ||
Input Differential Impedance | ZIN | 90 | 100 | 110 | Ω | ||
TX Disable | Disable | 2.0 | Vcc | V | |||
Enable | 0 | 0.8 | V | ||||
Receiver | |||||||
Centre Wavelength | λc | 1260 | 1270 | 1280 | nm | ||
Receiver Sensitivity | -20 | dBm | 3 | ||||
Receiver Overload | -8.0 | dBm | 3 | ||||
LOS De-Assert | LOSD | -21 | dBm | ||||
LOS Assert | LOSA | -35 | dBm | ||||
LOS Hysteresis | 0.5 | 4 | dB | ||||
Data Output Swing Differential | Vout | 400 | 600 | 800 | mV | 2 | |
LOS | High | 2.0 | Vcc | V | |||
Low | 0.8 | V |
Note 1: The optical power is launched into SMF.
Note 2:Internally AC-coupled.
Note 3: Measured with a PRBS 231-1 test pattern @9953Mbps, BER ≤1×10-12.
Mechanical Specifications