Electric power pneumatic driven Shotcrete Equipment For Sale light weight

Shotcrete Equipment For Sale

Stop spraying of Shotcrete Equipment For Sale:
1. Stop the machine and blow out the excess material in the conveying pipeline.
2. When the pipeline is clean and no material is ejected from the nozzle, close the water valve at the nozzle.
3. Finally, close the total air duct valve.
4. The mixing material can be retained in the hopper when the injection operation is interrupted briefly.
5. At the end of a long pause or shotcrete operation, stop feeding, let the machine continue to operate, until the hopper and the residual material in the rotor is finished, and at the same time to add a little wet sand to the hopper and the residual material in the rotor cavity cleaning spray out.

Parameters of Shotcrete Equipment For Sale:

Operation Method of Shotcrete Equipment For Sale:
After the preparation work is finished, the mixing material can be added to the machine. The machine operator should first open the main valve, the valve of the upper air duct opens 1/3 circles, and then adjust the air pressure of the lower air duct (to the cyclone) to about 0.05-0.1 MPa (depending on the delivery distance). Then the sprayer opens the nozzle valve and gives the wet rock surface. At this time, the operator can start the machine and start shotcreting. Now the working pressure is about 0.2-0.4 MPa. According to the water-cement ratio of mixtures and the length of conveying distance, after adjusting and determining the wind pressure to the cyclone, the upper air pipe valve is opened again until there is no more material leakage at the machine outlet.

Pictures of Shotcrete Equipment For Sale:

Construction Site and Warehouse of Gunite Concrete Machine: