3HP Swimming Pool Filter Mit Pumpe Swimming Pool Iron Cast Pump

Features:

1. Excellent Flow rate suitable for spas and pools up to 2000 litres

2. Suitable for spas including Salt, Chorine, Inground and Above Ground

3. Corrosion Resistant and Chemical-resistant thermoplastic body

4. Tough durable construction for longer lasting life

5. Built-In Thermal Protection

6. Instruction manual for ease of installation and use.

7. Anti spin-off impeller.

8. A large see-through strainer, super-size debris basket.

9. Special design shockproof basement

10. Good quality and modern design

11. Low operation noise

12. Single or three phase

13. Anodized motor body

14. Huge pro-filter for less cleaning maintenance

FQS swimming pool water pump is able to use in the salt water or chlorine filtered pools. Its built with a corrosion resistant marine grade cast iron motor housing and chemical resistant thermoplastic filter and engineer plastic pump body which allows the pump to be tough and durable. It provides high effective cleanin filtration basket which designed to capture and prevent fine debris from entering the pump,make the pump to supply a long time service.

Direct coupled type pump units:the chassis must remain stable, so as not to damage the coupling.
Belt wheel type pump units:the two pulleys must be aligned, the belt loose or tighten must be moderate. If the pump doesn't turn, it is generally because the impeller-ring get rusty, you can use the mallet knocking the coupling axially.Pump mounting height(in order to suction the water tank as the base)should be less than the permit smoking on 1-2meter high vacuum.

INSTALLATION
Only qualified licensed electrician should install pump and wiring.
IMPORTANT ELECTRICAL
Electrical Contractors Please Note: All 220/380 Volt 50Hz pumps must be wired to the main power
supply through an approved and correctly rated electrician.
PUMP MOUNT MUST
Be solid Level Rigid Vibration Free.
Allow use of short, direct suction pipe. (To reduce friction losses & don’t install the pump more
than 3M geometrical height from water level)
Allow for gate valves in suction and discharge piping.
Have adequate floor drainage to prevent flooding.
Be protected from excess moisture.