HDMI 2.0 , over Single cat5e/6(60M), 4K x 2K , Extender

Introduction

The HDMI2.0 60M HDMI extender uses one single Cat5e/6(recommended)cable instead of HDMI cable,you can extend the 4K signal to 60 Meters.The purpose of the extender is to achieve long-distance signale transmission with low- cost wires.

Features

1. Signal transmission :cat5e or cat-6(recommended) cables up to 60

meters instead of HDMI cables are connected between TX and RX

Extender;

2. Compliant with HDMI2.0, HDCP2.2 and DVI 1.0;

3. Support video format up to 4k2k@60Hz with 24bit RGB/YcbCR

4:4:4/YCBCR4:4:4,and up to 4k2k@60Hz with 12bit YCBCR 4:4:4;

4. Support 3D frame sequential video format up to 1080p@60;

5. Support EDID Switch;

6. Audio format support :

DTS-HD/Dolby-trueHD/LPCM7.1/DTS/Dolby-AC3/DSD;

Panel Descriptions

Please study the panel drawings below and become familiar with the signal

input(S),output(S)and power requirements.

Transmitter Panel

Status --------------------------Power/HDMI Status indicator

HDMI Input -------------------------------------HDMI Input port

DC/5V--------------------------------------DC Power Input Port

EDID---------------------------------------------------EDID switch

Cat5e/6 -----------------------------Network cable output port

Receiver Panel

Status -------------------------Power/HDMI Status indicator

HDMI Output -------------------------------HDMI Output port

DC/5V-------------------------------------DC Power Input Port

Cat5e/6 -----------------------------Network cable input port

Connect and Operate

Application

(Point to point application)

1. Connect source device with transmitter by one HDMI cable(Max=10M).

2. Connect display device with receiver by one HDMI cable(Max=10M).

3. Connect TX with RX by one cat5e/6(Max=60M).

4. Connect the power supply to the TX and RX.

5. LED indicator:When a signal is input to work,steady blue light.