J107 Production introduction

J107 Basic information

Each plate contains two parts:

Metal plate--- It is an important heat transfer element for pressing metal sheet with corrugation, sealing groove and corner hole.

Corrugated not only can strengthen heat transfer, and can increase the sheet and rigid, so as to improve the bearing capacity of the plate heat exchanger, and because turbulence prompted the liquid state, so it can reduce the formation of sediment or dirt, play a role in “self-cleaning”.

Sealing gasket--- Installed in the slots along the perimeter of the plate of the gasket and seal plate between the peripheral, prevent fluid leak outward, and according to the requirements of design, the sealing part of the Angle of hole, the cold and hot liquids according to their respective port flow.

Material: Stainless steel 304, Stainless steel 316L, Titanium

Advantage: Produce plastic deformation and have certain strength

J107 Feature

• Advanced plate design to improve heat transfer efficiency.
• Uniform distribution of fluid, accurate positioning.
• Common types of plate heat exchanger plates at home and abroad.
• Reasonable shunt area, enhance corrosion resistance, improve the utilization rate of heat exchanger area.
• The reverse flow of the two fluids greatly improves the heat exchanger efficiency.
• Parallel piping of the same fluid inlet and outlet simplifies engineering installation.
• Single plate, simplified maintenance.

Parameters

Why Choose Us?

We seek an understanding of the working conditions for you, and carries on the effective communication with your engineer, to make a perfect solution, It will be more accurate, reducing purchase cost and energy consumption (Water, Electricity and Gas).

Our technical engineers can according to user’s working conditions, for our customers to provide professional selection plan and drawings, and we will choose the appropriate solutions, to provide a stable, efficient service for you.

We will give more cosideration to customers’s working conditions in order to reduce their equipment purchasing cost and energy consumption of processing operations (Water, Electricity and Gas).