Release Film Slitting Machine For 1300mm width

Detail description: suitable for release film slitting and rewinding.

Roll slitting is a shearing operation that cuts a large roll of material into narrower rolls. There are two types of slitting: log slitting and rewind slitting. In log slitting the roll of material is treated as a whole (the 'log') and one or more slices are taken from it without an unrolling/re-reeling process. In rewind slitting the web is unwound and run through the machine, passing through knives or lasers, before being rewound on one or more shafts to form narrower rolls. The multiple narrower strips of material may be known as mults (short for multiple) or pancakes if their diameter is much more than their width.[1] For rewind slitting the machine used is called a slitter rewinder, a slitter or a slitting machine – these names are used interchangeably for the same machines. For particularly narrow and thin products, the pancakes become unstable, and then the rewind may be onto a bobbin-wound reel: the rewind bobbins are much wider than the slit width and the web oscillates across the reel as it is rewound. Apart from the stability benefit it is also then possible to put very long lengths, (frequently many tens of kilometres), onto one bobbin.

Characteristics:

1. The two rewinding motors cooperate with the main motor to work as three motors motion control, the main motor blocks the unwinding and the rewinding motor control the tension, the tension of the finished product is stable, good rewinding appearance.
2. The rewinding arm adopts the pneumatic coupling control the balance, the contact pressure can be adjusted automatically during rewinding, the contact pressure can be set. This machine can also be equipped with discontinuous rewinding, cut other materials more widely.
3. The operation interface adopts LCD touch screen, various rewinding conditions and working conditions can be set directly on the screen, the control part adopts PLC to control the machine operation, with self-test system.
4. The machine drive uses AC motor and frequency inverter; acceleration and deceleration are stable and fast.
5. Optional with slat type air pressure shaft and pneumatic friction shaft, suitable for more material range, the shaft change is specially designed, can be change at any time.
6. Auxiliary discharge device, the material outfeed pass surface impression roll, material more even, and reduce the noise (suitable for adhesive material)
7. Separate type unwinding stand, for bigger unwinding diameter.

Specification: