Automatic High Precision Stainless Steel Coil Slitting Machine Production Line

YBT Automatic Stainless Steel Coil Slitting lines consist of an uncoiler for holding the wide coil, one or more slitters, and a coiler for simultaneous recoiling of all the slit strips.Slitting is the operation of cutting a wide strip into a lots of narrow strips by passing the strip between circular cutters or blades.

Detail of of slitting line:

A .Coil loading car :loading coil into decoiler's arm .moving in rails, lift up and down power from cylinder

B . hydraulic decoiler :Hold coil and open it ,feeding to next step one .Spindle is made of 40 cr solid round steel by rough turning, conditioning, car etc

C . Pinch roller :pinch sheet to loop bridge, drived from motor power

D .Loop bridge and Side guider and Slitter: 1.Keep enough Coil in pit loop so the line can work well ,and make each part's speed in little difference.2. guide sheet going with right way to the slitter, hand adjust the width by wheel 3.slit the coil into strips according to knife and spacer setting

E .Scrap winder: Check the details below

loop bridge two : Make sure slitting strips to keep line working in good condition, also help Slitter coodinate with recoiler in synchronous working, it set sensor inside to adjust these two parts working with same speed

tension Unit: has disc type separate shaft, pad tension and reversing roller.

F. hydraulic recoiler: recoiling each strips to many coils, it consist of separate disc shaft, recoiler and push out device, recoiler mandrel expansive and contractive by hydraulic power through wedge

Coil unloading car: removing the finished coils out, level working in rail, lift power from cylinder, V type saddle

Description Part E And Pictures :Scrap winder: winding the wasting edge of coil together, it has two options, one is both side winder, another is baller type one side winding.

Tension Unit:

Disc type separate shaft used to separate each strips in its direction going, not mixed in a shit

Pad tension have two steel pad to press each strips in average pressure to keep tight between tension and recoiler

Reversing roller are used to give required tension direction for recoiler

Cutting tooler material :made by high quality mold steel Cr12 with heat treatment

Applicable Materials: stainless steel,Tinplate, silicon steel, aluminum, copper, and galvanized steel, etc.

Application:suitable for the longitudinal shearing of the metal coils and rewinding coils.
Advantages:Easy to operate,excellent material utilization, Stepless shearing speed regulation , slitting quality is high, , etc.
Structure: consist of uncoiler, feeding and positioning, slitting unit, recoiler, etc.

Training and Installation
1 . We offer installation service local in paid, reasonable charge.
2 . QT test is welcome and professional.
3 . manual and using guide is optional if no visiting and no installation.

Certification and after service
1 . Match the technology standard, ISO producing certification
2 . CE certification
3 . 12 months warranty since the delivery. Board.