1. Punching: Full range of universal punches and dies are available.unique style allows for large angle iron punching and large channel punching.Large viewing window on stripper swing away design for ease of operation.large two piece gauging table with rulers and stop as standard fittings.Quick change coupling nut and sleeve for rapid replacement of change.
2. Shearing: Round and square bar shear has multiple holes for a variety of sizes. Adjustable hold down device for round/square bar,channel/beam cutting. Large strong guarding for max safety. The angle shear has the ability to cut angle at 45°both top and bottom leg. This gives the operator the ability to make a picture frame corner for perfect welds.Diamond shaped blade for quality cuts that is minimal material lost and deformity. Easily adjustable hold-down device for accurate plate cutting.Large 15″squaring arm with inlaid scale.Special anti-distorted blade for quality cutting.Lower blade has four usable edges.There is screw allow for gap adjust no shim needed.
3. Notching: Unique design allows for cutting of angle and flat bar. Electrical interlock safety guard and three gauging stops for precise positioning.The notching section of this hydraulic ironworker is perfect for notching out metal plate, angle iron and much more. The notching station also has an over sized table with material stops. This section of the machine can also be outfitted with the optional vee notcher.
4. Bending: Also bend the plate below 500mm. All the components of Machine are of the highest quality in their safety, function.

Standard Series:

Only one operator can work on this machine.

With one standard set of unit, including one pump, one motor and one valve.

Manual clamping

Without temperature cooling system

S series:

Only one opertaor can work on this machine.

With one standard set of unit, including one pump, one motor and one valve.

Manual clamping

Automatic clamping system in angle and plate shearing station

Temperature cooling system

D series:

Dual working ironworker(which means two operators can work on the machine at the same time)

With two sets of hydraulic units, including two pumps, two motors and two valves.

Automatic clamping system in angle and plate shearing station

Temperature colling system

Standard Functions:

Punching; Angle, C-channel Punching; H-beam Punching

Angle Shear; Round Bar Shear; Square Bar Shear; Flat-Bar Shear; Angle Miter Shear

Notching;

Optional Functions:

Pipe Notcing

Pipe Punching

Press Brake

Angle Bending

Radius Corners

Rounding off Corners

Bialateral Rounding off

Vee Nocthing

C-channel Jointing

I-Beam Shear

Channel Shear

	Punching Station A full range of punches and dies are available for various punchig needs. Quick change retaining nut system for fast punch tooling change. Thoughtfully designed stripper for visibility, safety andease of use. A large 2-piece table with scales and gauging stops isstandard on all models. Stripper with interchangeable plates of various openings to minimize deformation is standard on all models
Flat Bar Shearing Station Specially machined upper blade to give a clean shear with minimum distortion. Lower blade has four usable cutting edges. Variable degree miter-cutting on angle flange. Easily adiustable hold-down. Support table with guides for accurate positioning.
	Angle Shearing Station Single shear with no material loss and minimal deformation. 45° miter-cut is easy and clean. Stationary blades with four usable cutting edges. Selectable corner radii on moving blades for optimumresults on small or large angles
Bar Shearing Station One hold-down for various sizes of square bar shear-ing and round bar shearing. Optional channel and section bar shear tooling is available for most models.(See specification chart fordetails)
	Notching Station ldeal for notching of flat bars and angles. Electrically interlocked safety quard for maximumsafety and visibility. Gauging table included with stops for precise positioning.