Appearance

This topic provides the appearance of the N66E-22 cabinet.

The N66E-22 cabinet is an IEC 600 mm middle standing pillar cabinet of NC purple grey.

The N66E-22 cabinet houses the MA5600T IEC subrack and MA5603T chassis.

The N66E-22 cabinet consists of the rack (main frame), a front door, a rear panel fixed by screws, and side panels on the left and right sides.

The door of the N66E-22 cabinet is removable and the top of the cabinet has the grounding point. All N66E-22 cabinets have the same key for the front door.

Figure 1 Appearance of the N66E-22 cabinet

Specification

This topic provides the dimensions, weight and power parameters of the N66E-22 cabinet.

Installation Size

Figure 1 Dimensions of the N66E-22 cabinet

Table 1 Dimensions and weight of the N66E-22 cabinet

NOTE:

For cabinet power parameters, see relevant PDB parameter requirements.

Configuration

The N66E-22 cabinet adopts the DC power. This topic describes the service subrack configuration, maximum number of subscribers and maximum power consumption of the N66E-22 cabinet.

shows the configuration of the N66E-22 cabinet installed with two service shelves.

Figure 1 Configuration of the N66E-22 cabinet installed with two service shelves

NOTE:

In , the filled holes are for floating nuts to fasten subracks.

Cable Hole

The power cables and subscriber cables are led into the N66E-22 cabinet from the top and the bottom of the cabinet. This topic describes the positions of cable holes at the top and the bottom of the N66E-22 cabinet.

The cables of the N66E-22 cabinet can be routed in the overhead cabling mode or the underfloor cabling mode.

In the overhead cabling mode, external cables are led into the cabinet through the top of the cabinet. shows the positions of cable holes at the top of the cabinet.

In the underfloor cabling mode, external cables are led intoshows the positions of cable holes at the bottom of the cabinet.

Figure 1 Cable holes at the top of the cabinet (top view)

Figure 2 Cable holes at the bottom of the cabinet (top view)

ESD Jack

The ESD jack of the N66E-22 cabinet is on the middle of the left mounting angle, which is used to connect the ESD wrist strap to prevent device damage caused by electrostatic discharge.

The position of the N66E-22 cabinet ESD jack, as shown in.

Figure 1 ESD jack of the N66E-22 cabinet

Return Material Authorization (RMA) Process

Standard Hardware Warranty Policy:

Original new sealed ZTE product: 1 Year

The Support Contacts:

If your ZTE products failed, you must contact your sales representative to verify product failure. If the problem still can't correct by remote support methods i.e. email or phone support, the RMA procedure will issue.

Cargo will be delivered within 1 day after payment arrived. Tracking Number will be offered once delivery done.

Uonel is one of the biggest Huawei Network Hardware distributor in china, founded in 2008. We are a global provider of netwotking products with more than 5000 customers.

We provide original new Huawei Routers,Switches,Firewalls,Wireless APs & controllers,OLTs,GPON modems,optical transceivers.Our company have more than $5million Huawei products in stock.

Most of our technical engineers had work exprience in Huawei company,we can provide network design&planning,configration,troubleshooting,maintenance and training service in world wide.