1 Meter 1/2 superflex RF coaxial Jumper cable with 4.3-10 male to 4.3-10 female connector
Description:
Jumper cables are mainly used between main feeders and antennas or between main feeders and system equipment. Jumper cables are used in areas that require extremely small bending radius. Jumper cable is premium soldered, premium molded in factory, assembled with fully soldered connectors. The use of jumpers provides greater flexibility, reduced mechanical stress on antennas and connectors and better accessibility of feeder terminations. Jumper cables offer outstanding electrical performance along with high durability for superior environmental sealing for long life reliability.
Features/Benefits:
Jumper cables are designed and produced to have features as below
● High pull-off strength
● Excellent V.S.W.R performance.
● Low and stable intermodulation.
● Weatherproof
Interface |
According to | IEC 61169-54 |
Electrical |
Impedance | 50 ohm |
Frequency | DC-6GHz |
| (DC-3GHz)≤1.08 |
(3-6GHz)≤1.12 |
PIM (@2-tone×20w) | ≤-165dBC |
Dielectric withstanding voltage | ≥2500V RMS, 50Hz, at sea level |
Dielectric Resistance | ≥5000MΩ |
Center contact resistance | ≤1.0m Ω |
Outer contact resistance | ≤1.0m Ω |
Mechanical |
Mating cycles | ≥500 times |
Watertightness (1m, 1hour) | IP68 |
Rosh-compliance | complianced |
Temperature range | -40℃~+85℃ |
Material and plating |
Body | Brass / Tri-alloy plating |
Center conductor | Phosphor bronze or bbrass/ Ag plating |
Dielectric | PTFE |
Gasket | Silicone rubbber |
Other | Brass / Ni plating |



