PLC Water-Tap With Sensor Switch Endurance 2 Station Tester EN15091

Product information :

It is designed and manufactured according to EN15091:2013 Sanitary tapware-Electronic opening and closing sanitary tapware, the test sample is Water-tap with sensor switch, It is used for endurance testing of the sensor switch of the water-tap to verify its reliability.

Test principle

The robot arm is driven by the servo motor to drive the human body analog sensing resistor to repeatedly enter and exit the sensing area of the sensor switch at a certain speed, so as to repeatedly turn on and off the sensor switch, so as to achieve endurance test. At the same time, the circulating water supply system and the hot and cold water conversion auxiliary mechanism are configured to simulate the normal operation process.

Structure

The equipment consists of an electrical control cabinet, a circulating water supply system, a frame and clamp fixture mounted on the frame.

Equipment dimensions: about: 1500 × 1300 × 1300 (mm) W × D × H

Equipment weight: 180kg

Performance parameters

Overview of test projects and processes:

1. Select the corresponding fixture according to the sample.

2. According to the requirements of the sample, set the robot arm stroke, forward/backward speed, forward/ backward pause time, total test times, and select the hot and cold water switch conversion auxiliary mechanism if the water-tap has the hot and cold water transfer switch. Press Start, the device will automatically run according to the set parameters, automatically stop when the number of tests is reached.

Use environment

Power supply: AC220V±10%/50-60Hz, power 6KW

Air source: 0.5-0.7MPa compressed air

Use place: atmospheric pressure 80 ~ 106kpa; ambient temperature 5 ~ 40 ° C; relative humidity (20 ~ 80)% RH; no vigorous shaking, vibration, no electromagnetic interference, no dust, no explosive and corrosive gas, good heat dissipation.