3.3mm 3.8mm 4.3mm 5.0mm Camlog Dental Custom Abutment

Camlog® Impression Coping Transfer Closed/Open Tray Compatible

3.3mm/ 3.8mm/ 4.3mm/ 5.0mm

Material:

Ti 6AI-4V ELI (Supply from Germany)

Feature:
- Titanium interface abutment
- Precision machined up to ± 5µm
- Combination of high fatigue strength
- Superior level of biocompatibility
- Exterior retentions for more cementation bonding

Approved by CE, ISO 9001, ISO 13485

Points of Camlog™ Dental Implant Impression Coping Transfer:

Indirect (closed tray) fixture level impression copings (Fig.1) consist of a three component set. The impression coping body with engaging indexing feature, a fixation screw and a plastic cap. Once the impression coping is properly seated and secured with the fixation screw, the plastic cap is pressed on to the impression coping body while three grooves machined in to the impression coping body engage three grooves inside the plastic cap. This plastic cap will be captured in the impression material and should stay in the impression material. Color coding follows the platform diameter identification scheme. Silver (no color), yellow 3.8, red 4.3, blue 5.0 and green 6.0mm.

Platform switching indirect impression copings (Fig.2) are marked with the letters "PS" printed on the impression coping body in addition to the platform dependent color coding for identification. These impression copings may only be used for SCREW-LINE™ implants with a catalog # beginning with a "K" and are not available for 3.3mm platform diameter implants.

Direct (open tray) fixture level impression copings (Fig.3) consist of a impression coping body and fixation screw. The impression coping body is color coded for platform diameter identification silver (no color), yellow 3.8, red 4.3, blue 5.0 and green 6.0mm. A special feature of the fixation screw lets the operator shorten the fixation screw without rotary instruments if necessary. The screw shaft is pre scored and may be "broken" at the score line by inserting a hex driver to the score line and snapping off the excess length of the fixation screw. Shortening the screw should not be done intraorally while the impression coping is attached to the implant.

Platform switching direct impression copings (Fig.4) are marked with the letters "PS" printed on the impression coping body in addition to the platform dependent color coding for identification. These impression copings may only be used for SCREW-LINE™ implants with a catalog # beginning with a "K" and are not available for 3.3mm platform diameter implants.