Electromagnetic Flow Meter with English / Korean / Polish / Turkish / French / Portuguese Language for Option

1. Introduction

The MLF electromagnetic flow meter is based on Faraday's law of electromagnetic induction and consists of sensors and converters. Used to measure the conductivity of a liquid or solid. In general, its conductivity should be greater than 5μs/cm (tap water, raw water conductivity of about 100 to 500μs/cm), can also be used to measure acids, alkali, brine, pulp or pulp and other media. However, these media must not contain large amounts of magnetic substances and bubbles.

MLF electromagnetic flow meter is an instrument for measuring liquid flow. Widely used in metallurgy, chemical, paper, environmental protection, petroleum, textiles, food, urban management, water plants and other industries flow metering.

2. Features

MLF electromagnetic flowmeter is explosion-proof design.

The function of low conductivity measurement.

There are 9 language options to meet the needs of different customers.

There are self-regulating functions and self-checking.

Different outputs are optional: Hart, RS485,Profibus, 4-20mA, frequency, pulse.

3. Selection of Liner Material

4. Selection of Electrode Materials

5. Dimensional Sketches

a. Dimension of Converter

Divided Type

Integrated Type

Battery Powered Type

b. Dimension of Sensor

6. Instrument Detection & Maintenance

Electromagnetic flow meters have a self-diagnosis function. In addition to power and hardware circuit failures, the system also alerts to other faults in general use. This information is prompted in the lower right corner of the screen.

1 Maintenance and repair

a) The sensor installation site should comply with section IV requirements, please keep the housing clean;

b) The transmitter should be placed in a clean, ventilated and dry place;

c) The instrument needs to be checked every two years and for high-precision users, the instrument needs to be submitted for review.

2 Transport and storage

a) The instrument must be packed before transport and handled with care.

b) Storage sites must be dry and ventilated to avoid the erosion of corrosive gases, and the ambient temperature should not be too low or too high

c) Storage time should preferably not exceed three years.

3 Out-of-the-box inspection

a) The package cannot be opened with a heavy hammer and care should be taken not to damage the instrument

b) Check the contents carefully according to the packing slip.