DC12V Staircase induction lamp controller iwith nfrared opposite radiation for controlling staircase

Staircase induction lamp controller electrical performance

can have load advertising lamp LED lamp, bath lamp, staircase lamp (this product is a pair of matching;

This product is designed with infrared opposite radiation principle, suitable for controlling staircase induction, machine tool, machine control, advertisement induction light display, door control detection, etc., mainly used in public places such as sprinkler shop, hotel, sprinkler bar, KTV, mall and so on.

Usage: install the infrared transmitter board and the receiver vertically opposite, the receiver must be aligned with the transmitter tube

1, if not aligned or too far away from sensing that there will be false positives, you can judge whether or not to align according to this, after alignment with something in the middle of the block sound and light can be

2, the music output can also be connected to the power amplifier circuit

3, each staircase to receive and connect to the receiver, the receiver must be aligned with the receiver vertically, and the receiver must be aligned with the transmitter tube 1. if it is not aligned or too far away from each other, there will be false positives. Put one on each side of the launch board.

5, the power supply can be used in parallel (the power of the power supply is greater than the sum of all load power).

6, the R 12 short circuit in the circuit, the step off the ladder with a delay of 5 seconds off the lamp effect. Fixed music is done with electricity, when you block one kind of music at a time, until you get a short jump needle when you block your favorite music.? The power outage returned to its original state.

7. when installing, each layer will transmit, the receiver will put a pair of power supply, connect the lamp bar and horn power connection, adjust and align the fixed installation, after the cloth wire, the sensors on both sides will be decorated with the laminate to decorate the wall, leave out the place of the induction hole, in order to decorate and beautiful, it is suggested to brush with paint.