2' TUBULAR SCREW PLUG Single Tube PTC HEATERS

Heaters' elements are PTC positive temperature coefficient semiconductors – making the heaters self-limiting.
That is, they reach a set maximum sheath temperature (which is below the ignition point of most combustible materials),
meaning they are especially safe for process applications.

LONG ELEMENT LIFE:
• PTC heater element lasts longer than conventional heaters.
• Will not burn out if run in air.
• Will not burn out due to scale or sludge buildup.

SAFE DESIGN:
Heater self limits its maximum operating temperature to 250 Celsius degree. This is lower than the ignition point of most plastics.
Will not melt tanks when a 1/2' (12mm) minimum distance is maintained.
Overtemperature protection devices are not required.
Safety is built-in, not added on.
Metal-grounded construction (earth ground).
Non-floating construction.

SIZES: 1,000 watts (1kW) to 6,000 watts (6kW).

VOLTAGES::
Three voltage ranges available: 110-120 volt, 200-240 volt, and 380-480 volt.
Heater is available in single or three phase power.

CORROSION RESISTANT HEADS: Vaporresistant, flame retardant polypropylene terminal enclosures each with 3-foot (.9m) flexible PVC liquid tight conduits.

OUTSTANDING PERFORMANCE:
Watt densities of 4 watts/cm2 ensure long service life.
Auto-stabilizing solid state element prevents hot spots and ensures uniform heating.
Heater derates itself in highly viscous and high temperature solutions. Consult factory for sizing assistance.

CHEMICALLY RESISTANT:
For use in most aqueous alkaline, electroplating and rinse solutions. Check our Solution Guide or with your chemical supplier for recommended sheath material. Available in:
304 stainless steel
316 stainless steel
Titanium


Consult factory for the following:
Longer wire and conduit lengths.
Extended cold zones.
Temperature and level controls sized to match the heater.

We recommend temperature controls and level controls for use with this immersion heater.

Electro-Polishing
Electro-polishing (Electropolishing) involves using electricity and chemical reactions to remove ions from the surface to deburr and reduce the surface roughness for a smooth, level, and clean surface, free of irregularities. Surplus power supplies deliver full power supply output performance, high efficiency, high-speed, DC output, connectivity, reliability, and ETL certification.

Products For Electro-Polishing
9HX SERIES Low watt density, 9 element fluoropolymer (PTFE) sleeved 304 stainless elements inert to most solutions. Three phase. 3000-18000 watts, 208-600 volts.	6HX SERIES Low watt density, 6 element fluoropolymer (PTFE) sleeved 304 stainless elements inert to most solutions. Three phase. 2000-12000 watts, 208-600 volts.	3HXOL SERIES Low watt density, 3 element, bottom heater. Fluoropolymer (PTFE) sleeved 304 stainless elements inert to most solutions . 3000-18000 watts, 208-480 volts.

PTFE Tanks

We can serve you in the teflon lined welded tank, small teflon lined vessel, mixer PTFE lined vessel and more PTFE teflon lined tank below.
Material used : PTFE, PFA, FEP, ECTFE, PVDF etched or glass backing.

Can store acid or alkali
high temperature resistance
Can custom sizes or even install PFA outlet and PFA inlet