Master Touch Multi Touch 15 Inch USB Interface Tape Bonding Touch Panel Assembly
1. Product Description
Master Touch 15 inch Touch Panel+LCM (Tape Bonding) is the lamination of touch panel and the LCD module. That is, simply use glue to laminate the touch screen and the four sides of the LCD screen, so there will be an air layer between them. The TP assembly attached by the frame bonding technology is thick, and the dust and water vapor are easy to enter the gap between the touch panel and the display. In addition, this type of lamination will make light reflection on screen obvious, so the display effect is much worse than that of optical bonding. But the advantage is that the lamination is simpler, the process is more mature, the yield is more stable, and the cost is lower.
2. Genaral Specification
2.1 LCD
Model | DV150X0M-N10 |
Size | 15 inch |
Resolution | 1024(RGB)×768 [XGA] 85PPI |
Luminance | 350 (Typ.) |
Contrast | 1000 : 1 (Typ.) |
Viewing Angles | 89/89/89/89 (Typ.)(CR≥10) |
Signal System | LVDS (1 ch, 8-bit) , terminal , 20 pins |
Operating frequency | 60Hz |
Driving Voltage | 3.3 V (Typ.) |
TFT thickness | 10mm |
2.2 Touch Panel
Outline Dimension | 326.5*253.5 | mm |
View Area | 305.13*229.1 (15 inch) | mm |
TP thickness | 4.3 | mm |
Total | 15.3 | mm |
Touch IC | EETI80W46 | -- |
Number of touchpoint | 10 | points |
Number of button | -- | - |
Interface information driven plate | USB | - |
The active information | -- | -- |
The type of Bonding with LCD | Frame bonding | |
Operation Temperature | -20℃~70℃ | ℃ |
Storage (cannot exceed 6 months) | Temperature: 23±3℃ (Before installation) Humidity:40%~70%RH | ℃ |
Temperature: -30~80℃ (After installation) | ℃ |
Item | Content |
Transparency | 85±10% |
2.4 Electrical Spec.
ESD Touch Side (Touch) | 4kv |
ESD Touch Side (Air) | 8kv |
3. Reliability
Item | Specifications | Remark |
High Temperature Operation | 70ºC, 48hrs | -- |
Low Temperature Operation | -20 ºC, 48hrs | Non-condensing |
Operating Temperature/ Humidity | 60ºC/90%RH, 500hrs | Non-condensing |
Thermal Shock | -30 ~ 80℃, 60 mins/cycle, total 48 cycles | -- |
4. Drawing
5. Details
6. Inspection
Equipment/materials: light box, ion fan, humidifier, film card, alcohol/ethyl acetate, finger cover, dust-free cloth, Vernier/digital caliper.
Inspection environment: 30cm ± 5cm from the product, temperature: 22 ± 2 ℃; humidity: 40% ~ 70% RH; cleanliness: Level 10000.
Inspection angle: vertical rotation angle: ± 30 °, from top to bottom; horizontal rotation angle: ± 30 °, from left to right.
Inspection illuminance: fluorescent lamp inspection area illuminance: 150
0-1800lux; table lamp inspection area illuminance: 1500-1800lux; It is convenient for internal uniform illumination requirements.
Background color: Black/white.
Inspection time: the inspection time of one piece of product shall not exceed 15 seconds.
7. FAQ