Master Touch 24 Inch EETI Controller Dust-free Cloth LCM Touch Panel Assembly
1. Product Description
Master Touch 17 inch Touch Panel+LCM (Tape Bonding) is the lamination of touch panel and the LCD module. That is, the four sides of the touch panel and the LCD screen are laminated with the glue, and there will be an air layer between the two. The advantages are that the lamination is simpler, the process is more mature, the yield is more stable, and the cost is lower, and it is easy to disassemble.
2. Genaral Specification
2.1 LCD
Size | 24 inch |
Resolution | 1920(RGB)×1200 WUXGA 94PPI |
Luminance | 900 cd/m² (Typ.) |
Contrast | 1000 : 1 (Typ.) |
Viewing Angles | 89/89/89/89 (Typ.)(CR≥10) |
Signal System | 51 pins LVDS (2 ch, 10-bit) |
Operating frequency | 60Hz |
Driving Voltage | 12.0±1.2V |
TFT thickness | 17.15mm |
2.2 Touch Panel
Outline Dimension | 546.4*352 | mm |
View Area | 518.8*324.4(24 inch) | mm |
TP thickness | 3.9 | mm |
Total | 22.05 | mm |
Touch IC | EETI80H83 | -- |
Number of touchpoint | 10 | points |
Number of button | -- | - |
Interface information driven plate | USB | - |
The active information | -- | -- |
The type of Bonding with LCD | Frame bonding | |
Operation Temperature | -20℃~70℃ | ℃ |
Storage (cannot exceed 6 months) | Temperature: 23±3℃ (Before installation) Humidity:40%~70%RH | ℃ |
Temperature: -30~80℃ (After installation) | ℃ |
Item | Content |
Transparency | 85±10% |
2.4 Electrical Spec.
ESD Touch Side (Touch) | 4kv |
ESD Touch Side (Air) | 8kv |
3. Reliability
Item | Specifications | Remark |
High Temperature Operation | 70ºC, 48hrs | -- |
Low Temperature Operation | -20 ºC, 48hrs | Non-condensing |
Operating Temperature/ Humidity | 60ºC/90%RH, 500hrs | Non-condensing |
Thermal Shock | -30 ~ 80℃, 60 mins/cycle, total 48 cycles | -- |
4. Drawing
5. Details
6. Notice
Due to the system of capacitive touch screen is made of glass, Please do not strong impact, The impact, Or Fall from height;
Please do not stack up TPs. Don’t load on TP;
Please do not put the capacitive touch screen itself or FPC direct contact with metal material;
When assembling, please do not bend or strength to pull FPC, Avoid to cause the injured;
When assembling, please do not touch ink face of back of TP, Avoid to scratches;
When assembling, please do not contact the visual area, if have dirty in VA, Recommend the use of anhydrous ethanol to clean;
Operation of the capacitive touch screen, Use finger or conductive touch pen, please; must avoid high voltage and static electricity.
7. FAQ