Maintenance
1.The system contains dedicate laser generator and electrical components. Heavily Shock and extrusion is not allowed when operating and storing the system. After each treatment, The joints arm should put on the original place. Use the dust-proof cloth to cover the system.
2.Clean the lens of the joints arm with the no water alcohol after each treatment. The lens is at the tip of the joints arm. Revolve the handle to joints arm can get the lens.Warning: Do not check and clean the lens when the system is on power.
Calibration of the specifications
3.The calibration of the output:
1)Turn on the system
2)Adjust the light guide system, make the laser pulse can direct at the centre of the reaction interface of the energy calibrator.
3)When the system is at WORK status, Choose lowest Frequency(1Hz) to test the energy of the output.
4.The main body contains input protective fuse to avoid the system destroyed by the over loaded high voltage and high current of the power supply.
The step of change the broken fuse: The fuse is at the back side of the main body. Loose the fuse cap and take off the broken fuse.
5.If the environmental temperature change too much, the explosive power will reduce, and at the same time, the thermal efficiency will increase. Then emit the laser to the printing paper. If there is smoke rise from the paper, the operator must ask the technician to check the optical-electrical switch.
6.When the error value between practical output and expected output is ≥±20%. The calibration