G13 Lamp Cap Gauge Bi Pin Go No Go Pin Gauge On Finished Lamps T8

G13 Gauge list:

Conforms To:

IEC60968-1, IEC60061-3 G13

7006-45-4

Go gauge for bi-pin cap on finished lamps G13
PURPOSE:

To check dimensionb bc-, F min., max
and the combined pin diametera displacement of pins
(including bosges)of bi-pin caps G13 on finished lamps.
TESTING:

The pina of the capa on finished lampe shall enter the gauge at surface and, when fully ingerted, the burface
of cap and gauge shall contact In this position the end of the pins ahall be co-planar with
or project beyond surface, but shall not projoct beyond gurfacey.
Each individual pin shall enter hole ei at surface o until the face of the cap and the aurface of the gauge contact.

7006-44-5

Go and not go gauge for unmounted bi-pin cap

PURPOSE:

To check dimensions min,emax,fmin.,gmax,max. and the combined pin dismeter and displncement of pins (including bossea) of unmounted bi-pin caps G13.
TESTING:

The pins of the cap shall enter the gauge at surfoce and, when fully inserted, the aurfaces of cap and gauge shall contact. In this position the ends of the pins ahall be co-planar with or project
beyond surfoce X. Each individual pin shall enter the hole ea until the boss of the pin and the surface
of the gauge contact, but they shall not enter hole. The boss of the individual pin shall enter hole b
at surface until the surfaces of the cap and the gnuge contact.

Application:

Guangzhou Shice Equipment offers a wide range of gauge to meet the most common standards including those from

IEC, EN, UL, GB,DIN,VDE and others.

Such standards require the checking of size & definition etc.

These gauges are constructed from senior stainless steel and appropriate steel with a hardness of at least 60 HRC and a roughness according to standard require.

Each gauge is supplied with a certificate of calibration.