MEASTEK MDP4700B High Voltage Differential Probe 7000V 100MHz Oscilloscope Probe
Key Features:
1. This series of high-voltage differential probes adopts an integrated design without any buttons, with a longer service life and a more user-friendly design;
2. The probe is equipped with a standard BNC output interface and can be used with any manufacturer's oscilloscope. (The input impedance of the oscilloscope is required to be set to 1MΩ; when 50Ω is selected, the attenuation factor will be doubled) to measure the waveform of the circuit under test;
3. The high-voltage differential probe has an automatic save function to prevent users from repeating operations after power failure.
4. The probe has good common-mode noise suppression capability, and the input end has a higher input impedance and lower capacitance, which can accurately and quickly measure differential voltage signals.
5. It can be widely used in the research and development, debugging or maintenance of switching power supplies, inverter electronic ballasts, inverter home appliances and other electrical power devices.
Specifications
Model |
MDP4700B |
Bandwidth (-3dB) |
100 MHz |
Rise time (ns) |
≤3.5 |
Accuracy |
1% |
Attenuation ratio |
1000X |
Maximum differential measurement voltage (DC+Peak AC) |
±7000Vpk |
RMS |
±5000Vrms |
Maximum input voltage to ground (Vrms) |
1000V CATII 2300V CATI |
Common mode voltage(DC+Peak AC) |
±7000Vpk |
Input Impedance | Single-ended to ground 20MΩ |
Two input terminals 40MΩ | |
Input Capacitance | Single-ended to ground <5pF |
Two input ends <2.5pF | |
CMRR |
DC >80dB |
100kHz>60dB | |
1MHz>50dB | |
Noise (Vrms) | <1.2V |
Delay time | Host: about 9ns |
BNC cable 1m: about 5ns | |
Overload indicator voltage threshold | >7000Vpk |
Overload indicator light (red light) | Yes |
Auto-save function | Yes |
Terminal load requirement | ≥100kΩ |
power supply | USB 5V/1A adapter |
Applications
1. Power electronics
▸ Switching power supply primary side waveform measurement (Vds>1200V)
▸ Inverter bridge arm upper and lower tube drive timing analysis
2. New energy
▸ Charging pile PFC circuit high voltage differential test
▸ Battery pack BMS balancing circuit voltage monitoring
3. Industrial control
▸ Inverter IGBT module turn-on/off loss test
▸ Servo motor driver high voltage bus ripple analysis
Packing List
Name | Quantity |
High-voltage differential probe | 1 piece |
Test hook | 1 pair |
Input extension cable | 1 pair |
BNC output cable | 1 piece |
Power output cable | 1 piece |
Power adapter | 1 piece |
Test report | 1 piece |
Warranty card | 1 piece |
Probe box | 1 piece |