MEASTEK UHCT6000A 6KA Ultra-high Voltage Probe 50MHz High Frequency Bandwidth | 12mV Low Noise For Power Transmission Line Fault Detection

1. Extreme current measurement: peak current 6KA, suitable for ultra-high voltage transmission line fault detection.

2. High frequency response 50MHz: accurate analysis of semiconductor device switching characteristics.

3. Low noise 12mV Vp-p: improve weak signal detection capability, suitable for scientific research.

4. Withstand voltage insulation 2KV: high safety protection level, meet high voltage laboratory standards.

5. Customizable lead length: up to 3m, flexible to meet long-distance measurement needs.

6. Plug and play design: USB power supply + BNC output, simplifying the operation process.

Technical Parameters

Note: If you need a larger range, please consult the manufacturer. It can be customized according to your requirements.

Other Technical Parameters

Product Description

1) Input interface: probe ring input interface.
2) Output interface: integrator output interface.
3) USB 5V power supply interface: standard USB (type B) interface, USB power supply cable as standard.
Probe induction ring body diameter: 3.5mm
Coil circumference: 100mm

Care And Maintenance

*The current transmitter can only be guaranteed to operate safely and trouble-free if it is properly transported, stored, installed, and carefully operated and maintained.
*Keep the probe clean and dry, and wipe it with a soft dry cloth.
*When transporting the probe, put it in the standard packaging to prevent shock.
*Do not force the flexible probe ring and connecting wire to avoid damage due to excessive twisting, bending or knotting.

Packing List

Notes

1. To ensure measurement accuracy, the measured wire should pass through the center of the probe ring during measurement.
2. The error is greatest at the junction of the induction rings, and the measured wire should try to avoid this area.
3. Make sure the probe ring is inserted in place (to the bottom) during measurement, otherwise it will affect the measurement accuracy.
4. When measuring the measured signal, if there is a strong magnetic field interference source nearby (such as a magnetic field radiation source composed of multiple coils), it should be kept as far away as possible, otherwise it will cause measurement errors.