LPD8806 Digital IC led strip lights DC 5 Volt 32 Leds / meter
Specifications:
1) Input Voltage: DC5V
2) IC type: LPD8806
3) IC quantity: 16 pcs / meter, one IC drive 2 led chips.
4) LED type: SMD5050 RGB
5) LED quantity: 32pcs/meter
5) Pixel: 32 Pixels / meter, one LED chip one Pixel.
7) Max power: 10W/meter
8) Bit: 8 bit
9) Greyscale: 256 level
10) Waterproof IP67.
Connection:
1) Signal wire: DC+, CLK, DAT, GND
2) DC+ and GND connect to power supplier; CLK, DAT and GND connect to controller
3) Relative controller: SPI controller support LPD8806; when use DMX decorder, can connect to DMX system
4) Support online control
Color:
1) Each Pixel can be controlled individually
2) Can show any color
3) Can be used as flexible led display screen to show image and video
Installation Notice:
1) Make sure the connection is correct according to the diagram
2) Pay attention to the parameters limit of voltage. DO NOT run over the peak value
3) Keep the surface of installation clean and smooth avoid breaking off
4) Avoiding the crook area just the position of LED and other components, in order to protect the product and extend the life span of the pr
● Working Voltage: DC5V
● PCB Color: Black or White color
● working with PIC,ARM,and arduino microcontrollers
● Power Consumption: Max 10W/M
● Brightness Level: 256 level
● Emitting Color: RGB/W/R/G/B/other single color
● Waterproof IP grade:silicon tube IP67/ non-waterproof
Two cable, two power cords, 14 mm wide white board, 256 level gray scale, can through the controller to achieve any result. Also, words, Numbers, English, images, animation, and so on. Form a complete set of controller: TSS - T1000S.