DIN rail industrial powerline Ethernet bridge

1Gbps G.hn WD-1000M-GD(800V)

Brief introduction

DIN rail industrial PLC Ethernet bridge is a powerline telecommunication product

which being developed by WonderTek Technology (KunShan) Co.,LTD., it supports the G.hn protocol and the actual bandwidth up to 400Mbps. The product has been widely used in many aspects just as railway, mines, industrial telecommunication

and metro etc..

1.1 Highlight

1.1.1 Technical parameters

 Support G.hn.

 Industrial DIN rail style installation

 Actual bandwidth up to 400Mbps

 The maximum transfer distance up to 1000 meters

 Self-adapt the rate

 Compatible with all G.hn devices

 One Domain Master can manage 15pcs End Point.

 There can be 16 groups(16 different Domain Master) of PLC telecommunication devices in the same power line circuit.

1.1.2Manageability

 Support Remote Firmware update(TR069)

 802.3D Ethernet Bridge.

 802.1Q VLAN.

 Quality of Service(QoS) .

 IGMO(IPv4)Snooping &MLD(IPv6)Snooping

 Support local web management

1.1.3Operating environment

 Working temperature: -40℃-80℃.

 Operating humidity: 10%-85% no condense

 Storage humidity:5%-90% no condense

1.1.4Design standards

 ITU-T G.9960

 IEC 60529

 IEC 50022

 IEC 60068-2-6

 MIL-STD-810G

1.2Features

Packet loss:≤0.1%(100M,load70%)

Support 7*24 hours all weather operation

hardware watch dog function

PING≤2MS

The quantity of the group ≤16pcs

1.3Immunity of ESD

The testing voltage which the device should be beared: ±6kV direct Discharge, ±8kV

air discharge. Discharge number in Each sensitive testing point: Plus-n-Minus 10 times each, Every time the discharge interval is 1 s, according to B/T 17626.2-2006.

1.4Immunity of electrical fast transient impulse group (Common mode)

The testing voltage which the device should be beared: between the power supply voltage port and ground: ±2.0kV, between signal circuit and ground: ±1.0kV, repetition frequency: 5KHz, test duration: 1 min/ time, testing times: Plus-n-Minus 5 times each. According to GB/T 17626.4-2008.

1.5Anti interference of surge impact

The testing voltage which the device should be beared: ±2kV, the interval of

continuous impulses: 1min/time. Test number: Plus-n-Minus 5 times each. According

to GB/T 17626.5-2008.(protection: all models protection and varistor series of

discharge tube type)

1.6Anti- vibration

Meet the demand of MX3 in TB1433(0-200Hz,2g acceleration, maximum amplitude

7mm), interface with no loose, device with no Sealing off and drop in the test.

1.7System topology

Application:

Smart Home, IoT, Automated Container Terminal, Factory Automation,

Smart Car Parking Lot