Brief introduction
The product transmits the network signals through the existing power line, not need to wire, where is a socket there is a network. The signal is stable and not be influenced by the obstacles. It is easy to use, just plug and play. It supports 128-bits AES data encryption, can insure the safety of data transmission. It’s stable function, strong anti-interference ability, higher level anti-thunder ability and advanced manufacture technique make the product can meet more demands of the market.
Topology

Specification

Features
Packet loss rate: less than 0.01% (100 m, 70% load measurement) ;
Support 7 * 24 hours work ;
Have hardware watchdog function ;
PING value is less than 1 ms.

Electrostatic discharge reactance immunity:
The test voltage monitoring unit should be able to withstand: ±6kV Direct discharge ,±8kV air discharge. Discharge time in each sensitive test sites: The positive and negative electrodes 10 times each ,each discharge interval 1s,The test procedure follows B/T 17626.2-2006.


Electrical fast transient bursts (common mode) immunity:
The test voltage monitoring unit should be able to withstand: The voltage between power supply port and ground :±2.0kV,Between signal circuit and earth :±1.0kV,repetition frequency :5KHz,Testing time:1min/time Testing voltage times: The positive and negative electrodes 5times each. The test procedure follows B/T 17626.2-2006.


Surge immunity (impact)
The test voltage monitoring unit should be able to withstand: ±2kV,Time interval between successive pulse :1min/time, testing time: The positive and negative electrodes 5times each. The test procedure follows B/T 17626.2- 2006. (Protection adopts the model of full protection and the varistor connects discharge tube in series )


Vibration defending
Meet TB1433 MX3 level requirements (0~200HZ, 2g accelerated speed, maximum amplitude 7mm),in the Testing process, it demands the interface no looseness, device desoldering and falling.