Cutter cutting tester

Product introduction:
一, Main parameters:
It adopts 5.7 inch (120 × 90) color LCD touch screen and Chinese menu display. Nominal size, print setting, maximum load, test, up, down, left, right, time, calibration. The menu on the LCD screen is controlled by touch, and the test data is printed on board. It is designed according to customer's requirements.
Nominal specification: blade specification
Set load: 0 ~ 400N, accuracy: ± 1%;
Cutting speed: 5 times / min ~ 60 times / min
Setting times: 1-200 times,
Print data: up to 200 data
Net weight: 12kg
Overall dimension: 400 × 290 × 240 (mm)

Partial list:
1. One main computer

2. One roll of printing paper 3. Two year warranty

4. Operation instructions
二, Specific equipment requirements:
1. It can be equipped with two kinds of blade angles (edge inclination angle 30 degrees, 45 degrees)
2. The blade edge is parallel to the crystal tablecloth, and the rear edge is aligned with the edge of the crystal tablecloth. The overall blade vertically cuts down into the 3mm crystal tablecloth with a depth of 2.5mm. The length range of 2.5mm after cutting should be consistent with the length of the blade edge. The resistance of each cutting in should be displayed.
3. The cutting distance is 1-5mm, the cutting material size is about 200mm, and the width is 20-30mm
4. The cutting times of each row are about 50-150. After the single row cutting, rotate the crystal tablecloth 180 degrees, install and cut the second row, and cut two rows with one cloth.
5. After continuous cutting, the alarm sound will remind to change materials.
6. In order to align the rear end of the single blade edge with the edge of the material after assembly, the blade mounting bracket should have a fine adjustment mechanism.
7. Record the cutting times.