Product introduction
Single Cable Combustion Tester is the most widely used and lower cost of cable fire performance test equipment, which can meet the standards IEC 60332-1-1:2004 in the provisions of technical indicators and requirements. Single cable combustion Tester is used to test the flame retardant property of the cable's insulating layer under abnormal conditions such as overheat and overcurrent. It can be used in vertical cable or fiber flame spread test, also can be test the state of flaming droplets during combustion.
Vertical burning chamber | W300xH1200xD450mm |
Gas | Use high purity propane gas or liquefied petroleum gas (provide by user-self) |
Specimen length | 600±25mm |
Area of specimen | Total section area less than 0.5mm2 |
Testing temperature | This device is located in a stuffiness room and the temperature keeping the 23±10℃ for testing |
Burning time | continuously setting between 0.1-999.9S, during the setting time flame could continuously burning the specimen |
Control function | Switch can choose to be manual or automatically according to the actual needed |
Gas flow range | 0.1-1L/min |
Area flow range | 0.1-1m3/h |
Burner | 500W for standards power, 125±25mm for total height of the flame |
Temperature measurement system | according to GB/T5169.14-2007 and IEC60695-11-03 standard requirements, including temperature copper (10g), K type thermocouple and diameter is 0.5 mm with stainless steel sheathed, stopwatch and thermometer etc. |