Application: Designed to test drawers, desks, cabinets and wardrobe.

Drawer Durability Tester is used to test the durability of the drawer slides of furniture.

Apply a certain load inside the drawer, repeated pull-out and close of the drawer.

After a certain number of cycles, check if the slide is still able to meet the requirements.

Technical Parameter:

STANDARD: BSEN 1728 , BIFMA X5.1

Technical specifications

This machine use for opening and closing drawer and must to fulfill minimum needed as follow:

Compressed air – 6 kg/cm²

AC motor –to control the height from 250-1000mm

Pneumatic cylinder – double acting cylinder with magnetic switch and maximum stroke 600 mm (adjustable). The cylinder shall have the fixture to hold any type of drawer handle to open / close the drawer without exerting force on the drawer system

Control panel/ console consists of :

Power supply: 240 Volts: 13 Amps: 50 Hz

ON/OFF switch button

6- digits Electronic Predetermine Counter (EPC)

The EPC will register every stroke of the cylinder up to six (6) digits,

Will stop the test operation to the preset stroke,

The EPC will display the number of stroke achieved during the test,

EPC also able to store the number of cycles when the power interruption take place and able to display the actual reading and continues counting when operation resumes

The signal shall maintain until the counter is reset

Note: one stroke is counted as one cycle

Service and Support
Our company focuses on research and development , we were produced some intelligent testing equipments over thirteen years, we continue to provide stable performance, high-quality equipment for product quality testing industry.At present, the company has 14 utility model patent technologies,2 patents for invention and participated in the drafting and formulation of nine national standards.
In cooperation we has a variety of testing units, industries, association partners and friends, accumulated a large number of detection industry insights and contacts, for those friends who just come into testing industry, we can learn from each other to communicate, explore the problems and difficulties encountered in testing.