High Sensitivity Conveyor Metal Detector For Food Processing , White

working principle:

When a ferromagnetic object enters the detection channel, generate the probe up and down through a strong magnetic field sensor signal and sends the signal to the signal receiving and processing blocks, and then scanned with a photoelectric sensor, high voltage blocks, sensitivity control manifold, manifold and signal reception signal output manifold and actuators to complete the testing.

Feature:

1. The latest development of highly integrated chip, ensure high performance and high reliability;
2. High sensitivity, high anti-jamming capability;
3. The data collected from all motor control using digital signal processing (DSP), highly intelligent;
4. Easy to use, automatic data processing and preservation, setting off every time to keep the boot;
5. The self-developed high-frequency switching power supply, fit and strong;
6. The use of integrated design, optimization of product design, reduce component count by computer instead of sophisticated electronic components, so the failure rate times reduced;
7. The precise control of the timing of the motor by the computer, to extend the life of the motor;
8. accurate count, qualified, defective, the total number;
9. unmanned operation is automatically shut down;
10. The machine can be set product testing time;
11. Needle machine with manual and automatic control of two options to select, using the operation more convenient and flexible.

Spectifications:

Composition structure:

1, the detection sensor (probe)
2, the circuit control system
3, the electrical machine
4. The conveyor belt
5, the rack
6, the wing housing
7, drive shaft
8. Optical Infrared emitters
9, the fixed foot
10, a control panel

maintenance:

1. Each test is completed, the conveyor belt response, probe maintenance on the machine removed the foreign body. Special attention probe window below the surface of any debris between the pallet and the conveyor belt is not allowed.
2. Rinse detector is not allowed to remove the debris. To ensure the conveyor belt, the probe control box dry.
3. When summer temperatures or a long time without much prior to use shall conveyor, pallet accumulation of moisture on the electrical box to dry before boot.
4. Regularly check the machine transmission parts refueling, if loose fastening screws should be tightened.