Plant Growth Epileds 4545 MIL Chip 460-465NM High Power 1W 3W SMD LED 3535 Blue Color

Specification

• LEDs Type: 3535 460-465nm Plant Grow Led
• Wattage: 3W
• Size: 35*35MM
• Wavelength: 460-465NM
• Current: 300-600mA
• Input Voltage: 3-3.2V
• Operation temperature: -30℃-+75℃
• Storage temperature: -30℃-+75℃
• Case Temperature: 85℃
• Junction Temperature: 125℃
• ESD Sensivity: 2000V HBM
• Continuous Operation Test: Tc=85℃ IF=350-600mA 1000H
• Low/High Temperature Storage Test: -40℃/30min~ +100℃/30min 100 Cycles

Product features

Plant Grow Light COB Chip:

1. ENERGY SAVING AND HIGH EFFICIENCY: you can buy lamp beads of different bands to assemble into plant lights of different wattage. It will speed up the growth for indoor plants with 3 times,it’s popular for greenhouse plants even in cold winter.
2. FULL SPECTRUM: 380-800nm wavelength full spectrum is suitable for all fruits, vegetables, hydroponic, flower,gardening,indoor plants at all stages.The wavelength of light can be fully absorbed.
3. GUARANTEE AND WARRANTY: 50000h service life,we are manufacturer and we will enable 3 years warranty , 50000Hours lifespan. Any questions,you can contact us freely,and we will be please to help you.

Application

User Manuel

1. Storage

To avoid moisture, we recommend storage conditions for the unopened LED +5 ~ +30℃
rela-tive humidity <60%. LED should be used within 168 Hrs. of opening the package. Please
make sure to dehumidify and vacuum pack the remaining/ unused LED. Dehumidifying condition:
+120℃±5℃ of 4Hrs. Effective age for the sealed led is one year.

2. Anti-static measures

Please take adequate measures to prevent electrostatic generation, such as wearing
electrostatic ring or anti-static fingerstall etc; any relative products like plant
equipment, machinery, carrier and transpor-tation units shall be connected to discharging
unit/ ground. The ESD sensitivity of this product is > 1000V(HBM), after assembly the final
lamp, please make sure to discharge Static Electricity by proper ESD equipment.

3. The soldering precautions

Soldering conditions: Reflow soldering is not recommended for this LED. If hand soldering,
set sol-dering iron temperature at 350℃ and soldering time not More than 5 seconds, after the
first soldering, make sure the substrate surface temperature returns to ambient temperature
before a second soldering. Please. make sure when soldering, there is no external force on the
soldering surface and silicon batardeau (such as pressure, friction or sharp metal nails, etc.),
to avoid gold wire deformation or dam-age and other abnormalities. If beyond recommended
conditions, we cannot guarantee the LED stability, please do the risk assessment first. During
assembly, please ensure that a good quality thermal paste is applied and distributed evenly over
the surface. While using thermal pad (Heat Sink), make sure LED is firmly tightened and there
is no gap between surfaces. In such heat-media products, through a pressure test of at least
500 volts.

Product Description