Addressable 5050 RGB APA102 Digital LED Strip Lights DATA And CLOCK Seperate - APA102C LED Strip :

Features:

1. Double line signal transfer Addressable Pixel LED Strip, APA102C IC inserted in 5050RGB diode.

2.144LEDs 144ICs per meter, each led can be cut, there is cut lines every 6.9mm;

3. 4PIN JST SM connector on both end for signal transfer and extra two wires for power feeding;

4. Black/White PCB, non-waterproof IP20, waterproof with silicon tube casing IP65;

5. Controller: SD card controller, Artnet, Ardunio and so on.

Description:

1. Control IC included, supporting numerous color-changing effects;

2. Control by SD controller,Arduino,DMX512,Artnet

3. Flexible PCB 5V low voltage input;

4. PCB Color: White&Black available for chooseAbsolutely addressable,each IC built inside RGB LED

5. 5M per roll,Customer’s size available also

6. The non-waterproof version strip attached white color

7. 3M tape on back side of PCB but the waterproof version only included 10pcs silicon clips and screw forinstallation use(without 3M tape)

8. Each led cut-able.

Advantage :

· The control principle: an IC control an LED form a loop (a), the controller IC on the FPCB through the control circuit inside the control to control the LED lights change different effects; such as flashing, chasing, jumping, Happy clockwise, counterclockwise Happy, Happy monochrome, color Happy, single chase from start to finish, running water, simulated lightning; changing effect this section is not limited to the current light bar controller built-in 94 kinds of effects can be based on customer needs , write your own; arranged in the form of screen can display, text, letters, pictures, animations, and so on.

· Environmental safety: high quality highlight SMD 5050 LED. With small power consumption, resulting in less heat, no glare, impact resistance and other characteristics. Low voltage DC 5V power supply, high security and reliability.

· Color can be varied by the controller needs to be adjusted according to the customer.

· Long life: average life expectancy of 50,000 hours.

· Cutting, welding facilitate freedom: each group of LED to form a loop, you can cut off any tangent meet customer requirements and demand for welding various lengths of light bar along the top.

· Soft: A soft FPCB board as a substrate, can butt, bending, cutting, and easily fixed to unsmooth surface.

· Light, thin: suitable for installation in narrow space inside

Parameter:

Strip cut schematic :

Led strip wiring diagram :

Picture :