T-1000B Sd Card Led Pixel Controller Programmable SPI Signal Output Full Color Dimmer

一 T-1000B System features,

1. 32~256 grade Gray level,Support software Gamma correction.
2. Support the rules and special-shaped handle.
3. 1 port output,can support 2048 lamp pixels.
4. SD Card control,offline control, the contents of the line control program stored in the SD card..
5. T-1000B store 16 files max, copy the files into SD card in turns.
6. Files be stored in the SD named as:00_1.led, 01_1.led, 02_1.led.
7. Compatible with single line or double line chips. Do not need to connect CLK line when use single line led fixture.

Note: 1. When the port of T-1000B is loaded with 512 lights, the playback speed can reach 30 frames/SEC. When the port is loaded with more than 512 lights, the frame frequency will increase
The number of lights increases and automatically decreases

二 Supported chips,

三 Prints .

TTL signal(245signal)

Note: for TTL signal output, the controller must be ground supplied to the luminaire (that is, connect the controller's ground output to the luminaire's ground).

四 Wiring Method

Note:

1. T-1000B is single-port output, which can take up to 2048 pixels;

2. When controlling single-line IC, only the DAT and GND of the controller are connected with the DAT and GND of the lamps and lanterns.When controlling a two-wire IC, the controller's DAT.CLK is needed

And GND and the lamp DAT,CLK and GND corresponding to the connection.

3. When creating a new project in the effect editing software, select the control model as T-1000B-IC

五 Special parameters

Memory card:

type:SD card(suggest using high-speed SD card)

Capacity:128MB—2GB

Format:FAT

Store file:*.led

Physical parameters:

Working temperature :-30℃—85℃

Working voltage:DC5V / DC7.5-24V

Working power:1W

size:L150mm×W71mm×H25mm

weight:0.35KG

signal port:3pin connect port

Note:

Before copy files to SD card ,The SD card must be formatted as FAT format

The SD card in controller can not be hot-swappable, plug the SD card every time, you must first disconnect the power supply