This is our 5mm Standard T-1 3/4 Type Full Color With Common Cathode LED.The Hyper Red source color devices are made with AlGaInP on GaAs substrate Light Emitting Diode.The Pure Green source color devices are made with InGaN on Sapphire substrate Light Emitting Diode.The Blue source color devices are made with InGaN on Sapphire substrate Light Emitting Diode.

Features:

• Uniform light output.
• Low power consumption.
• I.C. Compatible.
• Long life-solid state reliability.
• The product itself will remain within RoHS compliant Version.

Applications:

• TV set.
• Monitor.
• Telephone.
• Computer.
• Circuit board, etc.

Notes:

1. All dimensions are in millimeters (inches).

2. Tolerance is ± 0.25mm (.010″) unless otherwise noted.

3. Protruded resin under flange is 1.00mm (.039″) max.

4. Specifications are subject to change without notice.

Absolute Maximum Ratings at Ta=25℃

Electrical Optical Characteristics at Ta=25℃

Notes:

• Luminous Intensity Measurement allowance is ± 10%.
• θ_1/2 is the off-axis angle at which the luminous intensity is half the axial luminous intensity.
• The dominant wavelength (λd) is derived from the CIE chromaticity diagram and represents the single wavelength which defines the color of the device.

Typical Electrical / Optical Characteristics Curves

(25℃ Ambient Temperature Unless Otherwise Noted)

Hyper Red:

Pure Green:

Blue:

Reliability Test Items And Conditions:

The reliability of products shall be satisfied with items listed below:

Confidence level: 90%. LTPD: 10%.

1) Test Items and Results:

2) Criteria for Judging the Damage:

*) F.V.: First Value.

Please read the following notes before using the product:

• Over-current-proof

Customer must apply resistors for protection, otherwise slight voltage shift will cause big current change (Burn out will happen).

• Storage

2.1 Do not open moisture proof bag before the products are ready to use.

2.2 Before opening the package, the LEDs should be kept at 30℃ or less and 90%RH or less.

2.3 The LEDs should be used within a year.

2.4 After opening the package, the LEDs should be kept at 30℃ or less and 70%RH or less.

2.5 The LEDs should be used within 168 hours (7 days) after opening the package.

• Soldering Iron

Each terminal is to go to the tip of soldering iron temperature less than 260℃ for 5 seconds within once in less than the soldering iron capacity 25W. Leave two seconds and more intervals, and do soldering of each terminal. Be careful because the damage of the product is often started at the time of the hand solder.

• Repairing

Repair should not be done after the LEDs have been soldered. When repairing is unavoidable, a double-head soldering iron should be used. It should be confirmed beforehand whether the characteristics of the LEDs will or will not be damaged by repairing.

• Caution in ESD

Static Electricity and surge damages the LED. It is recommended to use a wrist band or anti-electrostatic glove when handling the LED. All devices equipment and machinery must be properly grounded.