Solderless 2 Contact Strip to Wire Flexible LED Strip Connector for Single Colour LED Strips

Solderless 2 contact flexible LED strip connector with pigtail, 8mm wide, clamp connection, used for connecting single color 3528 or 2835 flexible light strips and strip segments to dimmer or power supply. Make the connection easy and quick without soldering, save much more time especially when you make large led strip project.

Specifications:
* Strip to wire connectors to create a solder-free quick LED strip installation
* Used for connecting SMD5050 RGB multi-color LED flex strip (10mm wide PCB, 4pin) to dimmer or power and so on
* Color: white
* Clip Type: 4 pin 10mm
* Compatible with both waterproof and non-waterproof light strips
(Please peel off silicon on the surface around soldering line area when install waterproof strips)

Installation Instructions:

Ensure your section of LED light strip has four contacts (+, R, G and B) and the contacts are clean.

Open the white clasp of the connector.

Insert the LED light strip into the clasp, under the prongs ,Note that the positive and negative are connected correctly with PCB Board.Making sure to match the + on the strip to the + on the clasp

Close the clasp

Gently pull on the LED light strip to confirm you've made a solid connection

Your connection is made!

Our 10mm RGB multicolor (5050) LED light strip connectors are a simple, frustration-free solution for all of our LED light strip connection and extension needs. These solderless connectors install with a simple clasp attachment, meaning that you can achieve a safe and secure connection without any tools. Suitable for all LED light strip applications including kitchens, cabinets, bedrooms, shelving, and displays. These connectors come in a variety of lengths and styles to meet your needs.

Easy to Use

Open

Open the wire clip. It should snap open with just a little effort.

Insert

Insert your 10mm LED light strip inside the clip underneath the two contact prongs, making sure the 12V side of the strip aligns with the + symbol.

Close

Snap the wire clip shut. Gently pull on the wire to confirm you've secured the strip inside the connector.