Mini Size Digital Laser Distance Meter Measuring Range 0.05-30m , Lightweight
Technical data
1. Use a target plate to increase the
measurement range during daylightor if the target has poor reflectionproperties.
2. Measurement accuracy could
reach +3mm in good conditions
(good measurement surface, roomtemperature). If under adverse
measuring conditions, such as thelight is too strong, the temperaturedifference is too large, or the
measured surface reflective strongly,the deviation over distance willincrease.
Model |
LDM-MINl3O |
Measuring range |
0.05-30m |
Measuring accuracy |
Typical±3mm |
Display accuracy |
1mm |
Laser assifiction |
Class 2M II |
Lasertype |
620-690nm,<1mW |
Area,Volume measuring |
● |
Continuous measurement |
● |
pythagoras masurement |
● |
Plus-minus method |
● |
Hitorial storage |
10 |
Show beep |
X |
Protection against splashes and dust |
IP54 |
Temperature range for opration |
OC ~+40C |
Temperature range for storage |
20C~ +70C |
Battery life |
20OO measurements |
Battery selecion |
300mA |
Laser sithofof atomaically |
After 3O seconds |
Lnstrument swich-of auomaticly |
After 3 minutes |
Dimensions |
75x34x16mm |
weight without(battery ) |
35g |
Charging volage |
5V |
AWARNING:
Flat batteries must not be disposed ofwith household waste. Care for the environment. Always prevent access tothe product by unauthorized personnel.And take them to the collection pointsprovided in accordance with national orlocal regulations. The product must notbe disposed of with household waste.Dispose of the product appropriately inaccordance with the national regulationsin force in your country.
Electromagnetic Compatibility (EMC)The term electromagnetic compatibilityis taken to mean the capability of theproduct to function smoothly in anenvironment where electromagneticradiation and electrostatic dischargesare present, and without causing electromagnetic interference to otherequipment.
Prohibited use
- Using the instrument withoutinstruction.
- Using outside the stated limits.
- Deactivation of safety systems andremoval of explanatory and hazardlabels.
- Opening of the equipment by usingtools (screw drivers, etc.), as far asnot specifically pemitted for certain
- cases.
- Carrying out modification orconversion of the product.
- Use of accessories from other
- manufacturers without the expressapproval of our company.
- Deliberately or irresposible behaviouron scaffolding, when using ladders,when measuring near machineswhich are running, or near parts ofmachines or installations which areunprotected.
- Aiming directly into the sun..
- Deliberately dazzling of third parties;also in the dark.
- Inadequate safeguards at the
- surveying site (e.g. when measuringon roads, construction sites, etc.)