Connector Technical Data | |||||||||
Model Number | MC08C1LCXSB-1B16-0B04-26CK10 | ||||||||
Contact No | 8 pin | ||||||||
Coding | X coded | ||||||||
Rated Current | 0.5A | ||||||||
Rated voltage | 500V | ||||||||
Termination | Crimping, Push Pull | ||||||||
Type | Y splitter cable | ||||||||
Contact Carrier | TPU+GF | ||||||||
Screw Nut | Brass CNC Nickel plated | ||||||||
Contact | Male: Brass, Female: Phosphor bronze | ||||||||
Pollution degree | 3 | ||||||||
Protection Degree | IP67,IP68 |
M12 splitters includes both M12 T connectors and M12 Y connectors in 4 and 5 positions. The M12 Y splitters are available in 4 and 5 positions with a shunting circuit or for parallel operation. The input side of the M12 Y splitter connector is a male M12 connector and the output is 2 female M12 connectors. The 4 and 5 position M12 T connector splitters are available in an unshielded version and a fully shielded model.
● Degree of protection IP67 IP68
● 8P poles are available
● TPU over molded and PA+GF or metal shell
● Sturdy metal coupling screws with anti-vibration design, 48 hours Salt Spray Test
● UV Resistant, Hydrolysis Resistant, Oil resistant
● Temperature Range: Dynamic -25 ~ 80℃, Static: -40 ~ 80℃.
● RoHS, REACH compliant.
● Reference Standard:IEC 61076 2 109
FAQ
● What are Y-cables used for?
What is a Y Cable? The function of a Y cable is to duplicate a single audio signal into 2 identical audio signals. The two signals can be connected to two new destination devices. A Y cable can also be used to change the connector type to avoid using a Y cable plus connector adapters in the same chain.
● What is a splitter in cable?
A splitter is a device used to split a cable signal between two or more devices, providing two coaxial cables to connect those devices. A splitter weakens the signal level. This can cause intermittent loss of service or, in rare cases, complete service failure.
● What are push-pull connectors?
The push–pull connector is a type of cable interconnect that provides a strong locking mechanism that is only released by squeezing the connector body, thus preventing accidental disconnects.