ML70C-PD 1 x 70w DALI & PUSH DIM led driver multi-output current slim design 280 x 40.5 x 22.8mm
Description
1, This driver is special for both DALI and push dimming function .
2. With Max 200vDC output ,for big load
3, Compatible with latest DALI interface IEC62386-101,IEC62386-102,IEC62286-207
4, Multi output current 350mA to 700mA selectable via DIP switch,one driver is applicable for many luminaires,save purchasing cost and inventory qty for customer.
5, Memory function: The driver has built-in permanent memory against power failure. Lights can return to previous dimming level when switch off and on again, even at mains restores.
6, No need additional synchrony wire, up to 15pcs drivers should be controlled by one dimmer.
7, Maximum length of the cable, from push button to last driver is 20m
8, Press-in terminals in primary and secondary side, easy assembly
9, Protection: Short circuit / Over voltage / Over temperature
10, 5 years guaranty
Mechanical Specification:
Specifications
| Input voltage | 220-240Vac |
Input frequency | 50-60Hz | |
Input current | 0.17A max | |
Power factor | ≥0.90 | |
Efficiency(Note1) | ≥85% | |
Leakage current | <0.5mA/240Vac | |
| Output current and load | 350mA 50-200VDC 400mA 50-175V DC |
Output load range | 1x70W max | |
Current accuracy | ±5% | |
Dimming mode | DALI, PUSH | |
| Working temp.(Ta) | -20~50℃ |
Surface temp.(Tc) | 75℃max | |
Working humidity | 20~90%RH non-condensing | |
Storage temp. | -40~80℃ | |
Life time | ≥50000hours | |
| Isolation class | Class II, SELV |
Protection class | IP20 | |
Short circuit | Protection type; auto rest | |
Over voltage | Protection type; auto rest | |
Over temperature | Protection type; auto rest | |
| Safety | EN61347-1 EN61347-2-13 |
EMC | EN55015, EN61000-3-2ClassC | |
EN61000-3-3, EN61547 | ||
DALI interface | IEC62386-101, IEC62386-102, IEC62386-207 | |
Approvals | CE | |
Withstand voltage | IN-OUT:3.75KVAC/5mA/1min | |
| 1, Efficiency is measured at 550mA/55Vdc output set by DIP switch |
Output current selection
PUSH Dim
Short push (<0.1sec): Ignore, to avoid reaction on AC spike.
Short push (0.1~1sec): Switch on or off.
Long push (>1sec): Dimming up or down, dimming automatically stops at minimum or maximum value.
Wring Diagram: