ML50C-PV2 1x50w 0-10V and push dimmable led driver 350mA to 1050mA (3-60Vdc) multi-output 202 x 58 x 30mm for LED Panel Light
Feature
1, Multi-selection output current range from 350mA to 1050mA,output voltage is 3 - 60 Vdc,min load 1pcs LEDs.
2, Two circuit design AC-DC-DC, Long life time with better dimming performance,no flicckering in dimming 0%-100%.
3, Dimming range 0 - 100%,workable for 0 - 10V,and 1 - 10 V dimmer.
4, Dimmable LED driver with primary PUSH, and 1-10V dimming interface.
5, Jumper design for switching different dimming modes, it is very convenient to select suitable dimming function as you required.
6, Memory function: The driver has built-in permanent memory against power failure. Lights can return to previous dimming level when switch off and on again, even at mains restores.
7, Synchronization: thanks to the MCU programme, up to 50pcs drivers should be controlled by the same switch. This means there is no need for any additional synchrony wire in larger installations, where many drivers should be controlled by one switch.
8, Maximum length of the cable, from switch to last driver is 20m.
9, Factory setting: 100% dimming level and 350mA output.
10, Reset the LED diver easily by a jumper.
11, Press-in terminals in primary and secondary side, easy assembly.
12, Protection: Short circuit / Over voltage / Over temperature.
13, Long life span 50,000h, 5 years guaranty.
Mechanical Specification
Specifications
INPUT
| Input voltage | 220-240Vac |
Input frequency | 50-60Hz | |
Input current | 0.26A max | |
Power factor | ≥0.90 | |
Efficiency(Note1) | ≥85% | |
Leakage current | <0.5mA/240Vac | |
OUTPUT
| Output current/voltage and load | 350mA 3-60V DC 21W max 5000mA 3-60V DC 30W max 550mA 3-60V DC 33W max 650mA 3-58V DC 38W max 700mA 3-58V DC 41W max 750mA 3-56V DC 42W max 850mA 3-56V DC 47W max 900mA 3-56V DC 50W max 1050mA 3-48V DC, 50W max |
Output load range | 1x50W max | |
Current accuracy | ±5% | |
Dimming mode | 0-10V, PUSH | |
ENVIRONMENT
| Working temp.(Ta) | -20~50℃ |
Surface temp.(Tc) | 85℃max | |
Working humidity | 20~90%RH non-condensing | |
Storage temp. | -40~80℃ | |
Life time | ≥50000hours | |
PROTECTION
| Isolation class | Class II, SELV |
Protection class | IP20 | |
Short circuit | Protection type; auto rest | |
Over voltage | Protection type; auto rest | |
Over temperature | Protection type; auto rest | |
SAFETY&EMC
| Safety | EN61347-1 EN61347-2-13 EN60598-1 EN60598-2-6 |
EMC | EN55015, EN61000-3-2ClassC | |
EN61000-3-3, EN61547 | ||
Approvals | SEMKO, CE | |
Withstand voltage | IN-OUT:3.75KVAC/5mA/1min; IN-FG:1500VAC/5mA/1min | |
OUT-FG:500VAC/5mA/1min | ||
NOTE | 1, Efficiency is measured at 1050mA/48Vdc output set by DIP switch 2, All parameters not specially mentioned are measured at 230Vac input, rated load and 25℃of ambient temp. |
Applications
For LED panel light, LED down light, led strip, led tube etc…
Wire diagram