Flue Gas Desulphurization Tower Ridge Vane Pack Demister Self Cleaning

Ridge type vane pack demister consists of two layers of vane packs and three layers of washing water. The gas stream flow through the first and second vane packs to eliminate the target-size mist. The standard module of the first stage vane pack demister is with pitch of vane 30mm, and the standard module of the second stage vane pack demister is with pitch of vane 25mm. The vane plates are fixed by positioning rods (both the upper part and the lower part are fixed). The positioning rods and each chevron plate have corresponding round holes, which are penetrated vertically with round rods, and the chevron plates and positioning rods are penetrated into the fastener layer by layer. Then it is welded with the blade to ensure that the positioning rod and the round rod will not fall off, and at the same time, the bearing capacity of the vane pack demister is increased.

Technical characteristics of ridge vane pack demister:

Unique design, without dead angle of demisting in the whole tower, triangle installation form, good stability, unique angle design. Hook on the chevron plate is an option, to gain droplet collection acceleration, and improve separation efficiency.

Technical Parameters of ridge type vane pack mist eliminator:

Vane Plate Parameters for Ridge Demister:

1. Height of the first stage vane plate: 170mm,

plate thickness: 3mm; pitch of vane 30mm;

Vane plate shape: streamline 2-channel.

2. Height of the first stage vane plate: 170mm,

plate thickness: 3mm; pitch of vane 25mm;

Vane plate shape: streamline 2-channel; hook in the middle of plate is an option.

3. Molding process: extrusion molding

Flue gas desulphurization industry is becoming more and more important as we pay more attention and effort to the environmental protection all over the world. In Hualai we produce vane pack demister mist eliminators for years, we are expecting to make more contributions to this global action. Welcome your contact anytime!