Easy Operating Full Automatic Cheap Scrap Radiator Recycle Machine

Copper aluminum separator is designed to process various scrap car radiators, refrigerator radiator, air conditioner radiators, etc..It works very easily. You feed in and the machine will cut open the aluminum fin and allow you remove copper pipe. Comparing with manual handling, it can help save a lot of labor and improve productivity.

Electric radiator recycling machine Application:
Various water tanks, convection radiators, steel radiators, aluminum radiators, copper radiators, stainless steel radiators, copper-aluminum composite radiators, etc., as well as the original cast iron radiators.

Specifications of Radiator recycling machine:

Main structure of radiator separating machine:
1. Compressing part: It is radiator compressing system, the gear compressor is used for removing aluminum part on the radiator.
2. Radiator input plate: Normally there are 3 parts for radiator input, and they have different width for different size radiators. Customer need to put proper size(center distance) radiator on it.
3. Handle: There are totally 6 handles on the machine to adjust blades inside it.
4. Motor: There are two motors on both sides of the machine.
5. Control panel: There are Start,End and Emergency buttons on the panel.
6. Blades: Blades used for cutting radiators.

A/C radiator separator machine Operating process:
1.Turn the reversing switch and check the rotating direction.
2. Inject oil into the two oil holes in the left and right side of the machine to lubricate transmission gears (normally once per 4 working hours).
3. Push different radiator into different material inlets according to their specs(19mm,21mm,25mm); the left side of radiators must touch the left side of material inlets; or the right side of radiators must touch the right side of material inlets (the first copper pipe in the lower layer shall be nearer to the guiding ruler,When two-layer radiators are processed, the left side of the radiators shall touch the left side of each Material Inlet, and the first copper pipe in the Upper Layer to the left side of each Material Inlet must be nearer than the first copper pipe in the Lower Layer to the Left Side of each Material Inlet. )
4. After radiators are taken into the machine, copper pipes and aluminum are separated and come out of the machine automatically.
5. According to the layers of radiators and their height, adjust each pair of Adjusting Wheels on the machine (after adjusting, tighten screws below).

FAQ:

Q:What’s the spare parts of the separator?
A: Spare parts of the separator are blades and belt, we will supply extra parts according to customers’ requirement.

Q:What’s the warranty time for the equipment?
A: 12 months. During the warranty period, if there is any problem due to quality,we will supply spare parts for free, and customers take charge of delivery cost.

Q:What’s ordinary delivery time of the separating machine?
A: Within 12 working days.