Stainless Steel Microwave Drying Equipment / Tea Flower Water Removing Equipment

1. Machine Introduction:

The Technical Indicators of Microwave Drying Equipment:
System Composition: microwave generator system, microwave suppression system, conveying system, control and test system, wet and heat removal system and feed inlet and outlet platform, etc.

2. Control System:

A. Control Mode:According to the craft interlock control. The far infrared thermometer will monitor the automatic interlock control in the production. It will display the working state and total output power of magnetron, it can show the exact location of each of the magnetron tube on the device and the working condition on the table. This made the monitor clear at a glance.Maintenance is convenient;
According to the process of material monitoring system, a chain (dry material use microwave automatic switch, there is expected to start, will automatically shut down when there is no materials, the drying craft of each product can be connected to computer programming to facilitate drying process operation, can set up multiple drying process).
B. Monitor temperature (first stage) type, location and equipment specification:The raytek non-contact infrared thermometer, LT, S, one set.
C. Temperature measurement range and precision: 0-500ºC precision±5ºC
D. Microwave power regulation scope:90KW segmented,adjustable and controllable
E. Others:Door switch protection 11 PM (interlocks will open the oven door in working state to protect outage ).

3. Operating Environment:

A.Voltage:3 Phase 380V±10%, 50HZ±10%
B. Total Power:about 120KVA
C. Environmental Temperature:-0-40ºC
D. Relative humidity:≤80%

4. Microwave System:
(1) Microwave Working Frequency:2450MHZ±50HZ
(2) Power of Microwave:90KW(adjustable)
(3) Microwave Case Number:11, Each case has a wet and heat removal mouth to speed up the the effect of drying materials.
(4) Total electric appliances are 110 sets.In order to keep moisture to evaporate faster and not stop the conveyor, specially design electric intensity distribution.Material can achieve effectively the effect of heating itself in drying and heating to achieve the the effect of energy saving and cooling.
(5) Microwave drying cabinets are 11, adopt the 2.0 mm (±0.2 mm) 304 stainless steel materials (cabinet is reinforcement), main frame is made of 202 stainless steel square tube .Outside the plate adopt the 1.0 mm (±0.2 mm) 201 # stainless steel material.
(6) Microwave Feed Inlet Part:feed imlet from the upside cabinet.
(7) Minimum Separation between Feed Mouth:>=24db
(8) Microwave Feed into Wave Ratio:≤1.6
(9) Mouth of the Microwave Suppressor:250mm
(10) Air-cooled Magnetron
(11) The methods and standard of microwave leakage and detection: microwave leak: meet the national GB10436-89 standard, ≤5mw/cm², meet GB5226 electrical safety standards.
(12) All parts of equipment are made of high quality microwave electric components:
(13) Wet removal system:The equipment is set up 11 wet mouths at the upside .Need to install 3 sets high pressure low speed centrifugal fan to remove the wet, and can reduce the temperature of the material to ensure better drying effect, strengthen removing wet at the bottom of the material.
(14) In order to ensure the uniformity of material in the drying process and dry effect, and especially adopt the wide body, low microwave density way design, more conform to the requirements of the material characteristics of the drying and low temperature drying process.