220VAC 240VAC 50Hz 60Hz Microwave Motion Sensor Rod Antenna Type

ON/OFF Function microwave sensor with rod antenna and set by remote controller

Features:

• Automatically ON base on detection of motion and OFF after the stand-by period.
• Keep the light off even detect motion when daylight is sufficient.
• Special design with rod antenna, make it happen to open a very small hole on the board for the module which will make the light more aesthetically pleasing.
• There will be a blind zone right below the center of light, It’s better for ceiling mounting than wall mounting.
• Operating voltage of 120-277V which make it widely used in many countries.
• Built-in mounting hole to be easily applied to the lighting fitting with screw.
• 4 pole plugged clamp terminal (L,N,N,L’) for 1.5mm²cable.
• Detection area, hold time and daylight sensor could be precisely set via remote control.
• IP rating would be IP20 and 5 years warranty.

Specifications:

Dimensions:

With the thickness of 14.9mm, it’s very easily to be installed inside of the lighting fittings with the screw.

With the diameter of 5.5mm of the rod antenna, it could help to downsize the hole on the lighting board which will make the light be more aesthetically pleasing.

Wiring Diagram:

With 4-pole terminal (Input grey L. N. Output grey N. L’), it’s very simple to be connected with the driver and LED light.

Detection coverage:

Max. detection range will be 12m for ceiling mounted; Max. Detection range will be 10m for wall mounted. Max. Mounting height could be 4m.

Application Demo - Function Demo-On/off control:

With sufficient daylight, With insufficient daylight, After the last detection

even when motion when motion detected, and the present hold

detected, light remains light ON. time elapsed, light OFF.

HD411SR.pdf