Technical and Replacement filters

Products simple operation introduction :

Before first use :

• Wash and rinse out the plastic water tanks thoroughly before use
• Remove the filter from its packaging then fully cover and soak in cold clean water for approximately 15 - 30 minutes then rinse off under cold clean running tap water until see the clear water then will start for using
• You may notice a fine black dust come out of the filter, this will happen on all new filters and when water is filtered through it the first couple of uses . This is no cause for alarm . It is just the dust from the activated carbon inside the filter. Although it looks unsightly , it will not harm you.

Insert filter and ensure it sits flat and fully seated

When you turn on the switch to " on" at the back of the unit , you will see BLUE LIGHT indicating the water

cooler is chilling the water . When the indicator light goes out indicating the water approximatly 600ml cold tank has fully chilled .

Blue Light : Water is chilling

Light goes out : The water has fully chilled for drinking

Technical and Replacement filters

Maintenance :

• Replace filter after 150 litres or 2 months of use or whichever comes first
• If the taste , smell or flow rate changes , it is recommended you change the filter immediately
• Sanitise the unit fully every 1 to 2 weeks. This will be based on the customers' requirement.

Notices :

Position :

• The unit is designed for light use at home or in a small office
• If the unit is damaged in any way , refrain from using it
• Keep away from direct sunlight
• Ensure the unit is appropriately earthed
• Ensure the unit has 100mm of ventilation all round
• Do not place near a heat source

Contact details:

NINGBO GOOD WATER SOURCE ENVIRONMENTAL PROTECTION ELECTRICAL APPLIACE CO.,LTD

CONTACT PERSON: JACK LIU

CONTACT PHONE: (86) 13884494576

E-MAIL: jackliu@miniwatercoolerdispenser.com

Whatsapple: (86) 13884494576

Wechat: Jackliu8886