Open circuit Axial piston variable pump , A4VSO180DR/10R-PPB13N00

Hydraulic adjustment LR2N and LR3N pilot-pressure dependent, basic setting Vg min
(for further information, see data sheet 92064)
With superimposed power control.
The displacement volume is adjusted proportionally to the pilot pressure in PSt.
The additional hyperbola power controller is superimposed on the pilot pressure signal and keeps the specified drive output constant.
Optional:
▶▶ Power characteristics, remotely controllable (LR3N)
▶▶ Pressure control (LR.DN),
▶▶ Remote pressure control (LR.GN)
▶▶ Electrical control of pilot pressure (LR, NT)

Filtration of the hydraulic fluid
Finer filtration improves the cleanliness level of the hydraulic fluid, which increases the service life of the axial piston unit.
A cleanliness level of at least 20/18/15 is to be maintained according to ISO 4406.
At a hydraulic fluid viscosity of less than 10 mm2/s (e.g. due to high temperatures during short-time duty) at the drain port, a cleanliness level of at least 19/17/14 according to ISO 4406 is required.
For example, the viscosity corresponds to 10 mm2/s:
–– HLP 32 a temperature of 73 °C
–– HLP 46 a temperature of 85 °C

Technical data

Robust high-pressure pump for industrial applications.

Size 40 ... 1000.

Nominal pressure 350 bar.

Maximum pressure 400 bar.

Open circuit.

Features

Variable pump with axial piston rotary group of swashplate design for hydrostatic drives in open circuit.

Flow is proportional to the drive speed and displacement.

The flow can be infinitely varied by adjusting the swashplate angle.

Excellent suction performance.

Low noise level.

Long service life.

Modular design.

Variable through drive options.

Visual swivel angle indicator.

Freely variable installation position.

Suitable for variable-speed drives.

HF mode for reduced data possible for HFC mode,special version available.