This USB Charge led puck lights built-in 700 mA lithium battery does not need to be powered by AA batteries, which saves you the cost of purchasing batteries. If the battery is almost dead, you only need a USB connection to charge it. This is practical and fast, and reduces environmental damage.
***When this product leaves the factory, it has only 40-50% power. When using it for the first time, please fully charge it to 100% so that the light can keep on for a long time.
1. This product has no memory function, and it will be restored to factory settings during the restart each time after it is turmed off.
2. Press the lamp shade above the lamp body, the first press is the warm white lamp, the second press is the red lamp, the third press is
the green lamp, the fourth press is the blue lamp, the fifth press is the dynamic mode 1(slow hoppiong change mode), the sixth press is the
dynamic mode 2(fast hoppiong change mode), the seventh press is the dynamic mode 3(non-polar change mode), and the eighth press is the off.
3. Long press the mirror plane of the lamp body to adjust the brightness (note: the mode 3 cannot adjust the brightness).
4. You can use the remote controller to control 16 colors you want to use for normally on.
5. You can set the timing function for turning off the lights. Use the time button on the remote controller to adjust the time. Firsst of
all, the timing time is 30 minutes, 60 minutes or 120 minutes, then the light flashes once for entering the timing. The timing function can
be used for static mode and dynamic mode.
6. This product uses Micro USB for charging, the red lamp is for charging state and the green lamp is for full charging state.
7. The remore controller is equipped with battery insulating strip, please unplug the insulating strip before use.
8. There is an independent switch attached at the bottom, please turn off the switch to prevent power consumption of it is not use for a long time.
9. Please do not immerse the product into water or disassemble it randomly.
Voltage: | 3.7V |
Power: | 0.3W |
Charging duration: | 2H |
Maximum lumen: | 30LM |
Shell material: | ABS+PCA |
Power source: | Micro USB |
Lithium battery content: | 700MA |
Warm light color temperature: | 4000K |
Independent color: | 16 Independent colors |
Lamp bead quantity | 3+3,6 Lamp beads in total |