Ultra Thin Electric Displacement Stage Motorized Linear Stage PP110 - 15

Product description

Standard stepper motor and DB9 interface, choose to any controller according to requirement .

The back of motorized stages has handwheel , it is for convenience for adjustment.

Standard hole is so easy for combine with other units, ensure convenience for multi-dimensional system.

Product features

■ the stepper motor is equipped with 9-pin port as standard, and our motion controller can realize automatic control.

■ the product structure is small and light, which is suitable for light load, low-speed use and scientific test.

■ high quality fine grinding lead screw drive, small lead, the same fine fraction can achieve high resolution.

■ the ingenious structural design of air elimination check nut can minimize the clearance of grinding lead screw pair.

■ the guide rail adopts cross roller guide rail, which is comfortable to move. It has the function of laterally adjusting the preload of the guide rail and eliminating clearance. It can be combined in multi-dimensional and two-dimensional.

■ the fine grinding of the bottom plate of the electric moving table and the reasonable fixing mode of the guide rail reduce the pitch and yaw of the electric moving table, and improve the straightness and parallelism of the movement.

■ the stepping motor and grinding screw are connected through high-quality elastic coupling, with synchronous transmission, good depolarization performance, reduced eccentric disturbance and low noise.

■ zero and limit switches are installed at both ends to facilitate accurate positioning and protection of products. Hand wheels are equipped to facilitate commissioning.

■ the base has threaded holes and through holes with standard hole spacing, which is convenient for installation and fixation.

■ optional: replace the servo motor and grating ruler, and then the product can be modified and customized.

Product specification

Product diagram